Panasonic AJ-D250P Case of a Dvcpro format tape, Case of a DV format tape, Stx Osf Etx

RS-232C

$Operation control commands

	Sends data of computer		Return data from VTR		Description of command
	[STX] OSD [ETX]		[STX] OSD [ETX]	Controls the tape playback speed.
				Set the VTR to the STILL PAUSE mode using the OSL
				command, and send the OSD command. Each time the
				OSD command is sent, the playback speed shifts by one
				setting in the direction of the arrows below.
				If the lowest playback speed is already set, the speed does
				not shift any further, and error code ER001 is returned from
				the VTR.
					In the case of a DVCPRO format tape
					+32.0 . +16.0 . +9.5 . +4.1 . +1.85 . +1 . +0.43 . +0.3 .
					+0.1 +0.03 . STILL . –0.03 .–0.1 .–0.3 .–0.43 .–1 .
					–1.85 .–4.1 .–9.5 .–16.0 .–32.0
					In the case of a DV format tape
					+32.0 . +16.0 . +9.5 . +3.1 . +1.85 . +1 . +0.5 . +0.3 .
					+0.1 +0.03 . STILL . –0.03 .–0.1 .–0.3 .–0.5 .–1 .
					–1.85 .–3.1 .–9.5 .–16.0 .–32.0
	[STX] OSF:n [ETX]		[STX] OSF [ETX]	Sets the tape playback speed in the forward direction.
Parameters
OIn the case of a DVCPRO
	format tape
	n = 0: STILL	6: a1.85
	1: a0.03	7: a4.1
	2: a0.1	8: a9.5
	3: a0.3	9: a16.0
	4: a0.43	A: a32.0
	5: a1
OIn the case of a DV format tape
	n = 0: STILL	6: a1.85
	1: a0.03	7: a3.1
	2: a0.1	8: a9.5
	3: a0.3	9: a16.0
	4: a0.5	A: a32.0
	5: a1
	[STX] OSL [ETX]		[STX] OSL [ETX]	Sets the VTR to the STILL PAUSE mode.
				The OSD command and OSU command are accepted after
				the VTR has been set to the STILL PAUSE mode by the
				OSL command.
	[STX] OSP [ETX]		[STX] OSP [ETX]	Sets the VTR to the STOP mode.
				When the VTR is in the STANDBY OFF mode, it is set to
				STANDBY ON.

<Note>

Refer to the RS-232 mode transition table (on pages 71, 72) for the conditions under which the operation control commands are accepted.

53