Panasonic AJ-D250P $ Query control commands, OIn the case of CTL data, CTL mode

RS-232C

$ Query control commands

Sends data of computer		Return data from VTR			Description of command
[STX] QAL [ETX]		[STX] ALV0 [ETX]			Supports only address level 0 of the MIS standards.
[STX] QAO [ETX]		[STX] AOm [ETX]			Queries the audio signal output channel or channels.
	m = 1: CH1
	2: CH2
	3: CH3
	4: CH4
	5: CH1 & CH2
	6: CH3 & CH4
	7: CH1+3 & CH2+4
[STX] QCA [ETX]		[STX] CUPdata [ETX]			Queries the user’s bit data which was preset in the TCG.
	data = U7U6U5U4U7U3U2U1U0
[STX] QCB [ETX]		[STX] CUSdata [ETX]			Queries the user’s bit data of the TCG.
	data = U7U6U5U4U7U3U2U1U0
[STX] QCC [ETX]		[STX] CCPdata [ETX]			Queries the current counter data (second increments).
	data = ghmmss				The following data is returned from the VTR, depending on
	OIn the case of CTL data				the mode which appears on the counter display.
	g = Blank: With a positive value				CTL mode:
	– sign: With a negative value				CTL data
	h =	0	9:	Hours	TC mode, UB mode, REMAIN mode:
	mm = 00		59: Minutes		TC data
	ss =	00	59: Seconds
	OIn the case of TC data
	gh =	00	23: Hours
	mm = 00		59: Minutes
	ss =	00	59: Seconds
[STX] QCD [ETX]		[STX] CDdata [ETX]			Queries the current counter data.
	data = fwghmmssff				The following data is returned from the VTR, depending on
	OIn the case of CTL data				the mode which appears on the counter display.
	f =	F: Fine			CTL mode:
		C: Coarse			CTL data
	w =	S: Search STILL			TC mode, UB mode, REMAIN mode:
		P: Search PLAY			TC data
	g =	Blank: With a positive value
		– sign: With a negative value
	h =	0	9:	Hours
	mm = 00		59: Minutes
	ss =	00	59: Seconds
	ff =	00	29: Frames
	OIn the case of TC data
	f =	F: Fine
		C: Coarse
	w =	S: Search STILL
		P: Search PLAY
	gh =	00	23: Hours
	mm = 00		59: Minutes
	ss =	00	59: Seconds
	ff =	00	29: Frames

55