SAT CONTROL SET | EN 15 |
Satellite Receiver Control Setting
Satellite receiver
Your recorder | Satellite Controller |
| |
| (suggested locations) |
Transmitter | Satellite Controller |
| |
Satellite receiver |
|
SAT CTL
AV2 (L-2) IN/DECODER
The following procedure is required if you receive satellite channels through a satellite receiver. Approximately 20 seconds before the SHOWVIEW timer programming ( pg. 28) or Express timer programming ( pg. 30) starts, the recorder sets its input mode to
Installing Satellite Controller
A Situate the Satellite Controller.
Place the Satellite Controller so that the path between its transmitter and the satellite receiver’s remote sensor is unobstructed.
B Attach the Satellite Controller.
Fix securely using the adhesive strip attached on the back of the Satellite Controller.
C Make connections.
Be sure to connect the recorder’s AV2
NOTE:
When connecting your satellite receiver, refer to its instruction manual.
D Connect the Satellite Controller to recorder.
Connect the Satellite Controller to the SAT CTL connector on the rear panel.
Back of recorder