JVC HR-S6711EU You can set the B.E.S.T. Biconditional Equalised Signal, Playback, Lot of noise

		EN 45
		* The default setting is bold in the table below.
8 B.E.S.T.		You can set the B.E.S.T. (Biconditional Equalised Signal
ON		Tracking) system to “ON” or “OFF” ( pg. 27).
OFF
8 PICTURE CONTROL		This feature helps you to adjust the playback picture
AUTO:	Provides the optimised picture	quality according to your preference. Normally select
	benefits of the B.E.S.T. Picture	“AUTO”.
EDIT:	System.	NOTES:
	Minimizes picture degradation
	during editing (recording and	● When you select “EDIT”, “SOFT” or “SHARP”, the selected
	playback).	mode will not change until you select another mode.
SOFT:		● When you select “EDIT” to dub tapes, be sure to select “AUTO”
	Reduces image coarseness when
		after you finish dubbing the tapes.
	viewing overplayed tapes containing
		● When “B.E.S.T.” is “OFF”, “PICTURE CONTROL” switches
	a lot of noise.
SHARP:		automatically from “AUTO” to “NORM”.
	Clearer, sharper-edged picture when
	viewing images with lots of flat,
	same-coloured surfaces such as
	cartoons.
8 AUTO TIMER		When this function is set to “ON”, the timer is
ON		automatically engaged when the recorder power is turned
OFF		off, and automatically disengaged when the recorder is
		powered back on.
		NOTE:
		For safety, when “AUTO TIMER” is set to “OFF”, all other recorder
		functions are disabled while the Timer mode is engaged. To
		disengage the timer, press # (TIMER).
8 O.S.D.		When this function is set to “ON”, various operational
ON		indicators appear on the TV screen. Messages appear in
OFF		the selected language ( pg. 13, 14).
		NOTES:
		● When you use this recorder as the source player for editing, be
		sure to set “O.S.D.” to “OFF” before starting.
		● During playback, the operation mode indicators may be
		disturbed depending on the type of tape being used.
8 DIRECT REC		When this function is set to “ON”, you can easily start
ON		recording the programme that you are watching on your
OFF		TV. Press and hold 7 and press 4 on the remote control,
		or press 7 on the recorder.
		NOTES:
		● When you use the Direct Rec function, be sure to use a TV
		offering T-V LINK, etc. and connect a fully-wired 21-pin SCART
		cable between the recorder and the TV ( pg. 8).
		● If “DIRECT REC” is set to “OFF”, the 7 button functions as
		described in “Basic Recording” ( pg. 23).
		● During the Direct Rec, “– –” appears on the front display panel.