JVC HR-S6711EU specifications Recording

			EN 59
RECORDING
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
1.	Recording cannot be started.	● There is no cassette loaded, or the	Insert a cassette, or using adhesive tape,
		cassette loaded has had its record safety	reseal the slot where the tab was removed.
		tab removed.
2.	TV broadcasts cannot be recorded.	● “L-1”, “L-2”, “F-1”, “S-1” or “SAT” has	Set to the desired channel.
		been selected as the input mode.
3.	Tape-to-tape editing is not possible.	● The source (another video recorder,	Confirm that the source is properly
		camcorder) has not been properly	connected.
		connected.
		● All necessary power switches have not	Confirm that all units’ power switches are
		been turned on.	turned on.
		● The input mode is not correct.	Set the input mode to “L-1”, “L-2”, “F-1”
			or “S-1”.
4.	Camcorder recording is not possible.	● The camcorder has not been properly	Confirm that the camcorder is properly
		connected.	connected.
		● The input mode is not correct.	Set the input mode to “L-1”, “L-2”, “F-1”
			or “S-1”.
TIMER RECORDING
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
1.	Timer recording won’t work.	● The clock and/or the timer have been set	Re-perform the clock and/or timer
		incorrectly.	settings.
		● The timer is not engaged.	Press # and confirm that “#” is
			displayed on the front display panel.
2.	Timer programming is not possible.	● Timer recording is in progress.	Timer programming can’t be performed
			while a timer recording is in progress.
			Wait until it finishes.
3.	“#” and “[” on the front display	● The timer is engaged but there’s no	Load a cassette with the record safety tab
	panel won’t stop blinking.	cassette loaded.	intact, or cover the hole using adhesive
			tape.
4.	The cassette is automatically ejected,	● The loaded cassette has had its record	Remove the cassette and cover the hole
	and “#” and “[” on the front	safety tab removed.	with adhesive tape, or insert a cassette
	display panel won’t stop blinking.		with the record safety tab intact.
5.	“#” blinks for 10 seconds and the	● # has been pressed when there are no	Check the programmed data and re-
	Timer mode is disengaged.	programs in memory, or the timer	program as necessary, then press # again.
		record information has been
		programmed incorrectly.
6.	The cassette is automatically ejected,	● The end of the tape was reached during	The programme may not have been
	the power shuts off and “#” and	timer recording.	recorded in its entirety. Next time make
	“[” won’t stop blinking.		sure you have enough time on the tape to
			record the entire programme.
7.	The SHOWVIEW system does not timer-	● The recorder’s channel positions have	Refer to “Guide Program Number Set”
	record properly.	been set incorrectly.	( pg. 55) and re-perform the procedure.