JVC SR-VD400E manual 10 EN, Adjusting tracking condition, Selecting monitor sound

10 EN PLAYBACK (cont.)

C Adjusting tracking condition

— Tracking Adjustments

Automatic tracking adjustment

This VCR automatically adjusts the tracking condition. Whenever you insert a tape and start playback, automatic tracking starts working and continuously analyzes the signal to enable optimum picture quality during playback.

D Selecting monitor sound

— Audio Monitor

You can select the desired monitor sound.

While playing back a tape on which stereo sound is recorded, press [A. MONITOR] on the Remote.

Each time you press the button, the sound changes as follows:

Manual tracking adjustment

If automatic tracking cannot eliminate noises well during playback, use the manual tracking following the procedures below.

● You can also use the manual tracking during slow motion

playback ( page 15). During slow motion playback,

simply press [CHANNEL +] or [–] on the VCR (or [TV/

S-VHS/VHS
L R	L

MIX

R

NORMAL

VCR CH +] or [–] on the Remote) to adjust tracking.

1 Activate manual tracking

Press [CHANNEL +] and [–] on the front panel at the same time during playback.

2 Eliminate the noises on the TV screen

Press [CHANNEL +] or [–].

●Press it briefly for a fine adjustment, or press and hold for a coarse adjustment. Watch the screen and continue adjustment until optimum picture and sound quality are achieved.

●To reactivate automatic tracking, press [CHANNEL +] and [–] on the front panel at the same time. The automatic tracking becomes active again.

“	L R	”: Normally select this.
		Hi-Fi sound is played back.
“	L”	: Sound on the left Hi-Fi channel is played
“R		back.
	”	: Sound on the right Hi-Fi channel is played
		back.

“NORMAL” : Sound on the normal track is played back.

“MIX”	: Both sounds on the Hi-Fi track and normal
	track are mixed and played back.

D-VHS

L R L R

“	L R		” :	Normally select this.
“	L”	:		Sound on the left channel is played back.
“R	”	:		Sound on the right channel is played back.

NOTES:

●The above indication appears when “SUPERIMPOSE” is set to “ON” ( page 39), though the monitor sound changes in sequence.

●If the tape being played back has no Hi-Fi sound track, the normal sound track will be heard regardless of this setting.