JVC SR-VD400E manual 102, 103, 105, 108, 201, 202, 203, 205, 301, 302

EN 51

Error Codes and Messages

Some error codes and messages may appear on the TV screen when operating the VCR. Refer to the chart below for the solution.

CODE	MESSAGE	DESCRIPTION
102	ÒREC PROHIBITEDÓ	● An attempt was made to make a D-VHS recording of a program for
		which only the analog information is copy protected.
		● While making a D-VHS recording of a program, a signal in which
		only the analog information is copy protected was input to this VCR.
103	ÒREC PROHIBITEDÓ	● An attempt was made to dub a D-VHS recording of a digitally copy
		protected program.
		● While dubbing a D-VHS recording, digitally copy protected
		information was input to this VCR.
		● This VCR supports copy protection technologies such as DTLA, and
		cannot record programs that employ digital copy protection.
105	ÒCAN NOT REC DIGITAL INPUT BY	● An attempt was made to make an S-VHS/VHS recording of a signal
	S-VHS/VHSÓ	from an i.LINK device.
	ÒCHOOSE ANALOG INPUTÓ	● The i.LINK connector on this VCR is intended only for D-VHS
		recording. This VCR does not convert a digital signal into an analog
		signal for recording. Switch to the analog input for recording.
108	ÒREC BY HS MODEÓ	● When 720p, 1080i signals are recorded in STD/LS3/LS5 mode, select
		HS mode to record program properly.
201	ÒWAIT A MINUTE	● Normal playback is being prevented by mosaic noise, etc.
	CALIBRATING. . .Ó	● Wait while the VCR calibrates itself so that it can output a normal
		image.
202	ÒCOPY RESTRICTED PROG OUTPUT	● When playing back a program that was copy protected in 1080i,
	480i VIDEOÓ	720p, or 480p mode, theVCR down-converts to 480i mode for output.
203	ÒCOPY RESTRICTED PROG CAN NOT	● An attempt was made to play back a tape containing a copy protected
	PLAY BACKÓ	program.
		● Even if you record a copy protected program, this VCR cannot play it
		back.
205	ÒCAN NOT PLAY BACK THIS TAPEÓ	● An attempt was made to play back a tape containing an invalid
		D-VHS recording.
301	ÒTOO MANY i.LINK INSTRUMENTS	● A signal containing too much data was input to the i.LINK connector
	READ INST.BOOKÓ	on this VCR.
		● There are too many devices with i.LINK connectors, such as VCRs
		and digital video cameras, connected to the i.LINK connector on
		this VCR. Turn off any devices that are not in use.
302	ÒCOPY RESTRICTED PROG OUTPUT	● When playing back a program that was copy protected in 1080i,
	480i VIDEOÓ	720p, or 480p mode, theVCR down-converts to 480i mode for output.