JVC SR-VD400E manual Changing Remote Control Code, 46 EN

46 EN MULTI-BRAND REMOTE CONTROL (cont.)

Changing

Remote Control

Code

[POWER][PLAY (3)]

IN F-1

+

The Remote is capable of controlling four JVC video recorders independently. Each of VCRs can respond to one of four codes (A, B, C or D).

This Remote control is preset to send A code signals because your VCR is initially set to respond to A code signals. You can easily change your Remote and the VCR to send and respond to B, C or D code signals.

When using four JVC VCRs, set the four VCRs and their Remotes to different codes, so that the Remotes can operate these VCRs separately.

1 Set remote operation mode

Set the [VCR/TV/CABLE/DBS] selector to [VCR].

2 Set remote control code for Remote

1 Press and hold [A/B/C/D].

2Press the ÔNumberÕ key [1] for A code control signals, [2] for B code control signals, [3] for

C code control signals and [4] for D code control signals.

3Press [STOP ( 7 )], and release [A/B/C/D].

1 5

2 - 1

VCR CABLE

TV /DBS

2- 2

2 - 3

NOTE:

When ÒPOWER SAVEÓ is set to ÒONÓ, you can not change the remote control code. Before changing the code, set ÒPOWER SAVEÓ to ÒOFFÓ ( page 39).

3 Turn off VCR

Press [POWER] on the VCR.

4Check remote control code for VCR

Press [PLAY (3)] on the VCR for more than 5 seconds.

●The code currently set appears on the front display panel.

5 Turn on VCR

Press [POWER] on the Remote.

●The code transmitted from the Remote blinks for a few seconds on the front display panel.

●After the code disappears on the front display panel, make sure that the VCR is turned on by pressing [POWER] on the Remote.

To control four VCRs with the same Remote

You can control four JVC VCRs by switching the remote control code for the Remote between A, B, C and D ( step 2), keeping four VCRs to different control codes.

●Press the ÔNumberÕ key [1] for A code control signals, [2] for B code control signals, [3] for C code control signals and [4] for D code control signals. (To change only the remote control code for the Remote, DO NOT perform steps 3 to 5.)

(Ex.) To set Remote to B code:

A/B/C/D	STOP	Release
	ABC
Hold	Press in succession
down