JVC SR-VD400E manual Preparations, Link Connections, Make connections

INSTALLING YOUR NEW VCR EN 5

Connections

Another					Digital HD Video
D-VHS Digital Recorder
(SR-VD400E)					Camera (JY-HD10)
	Y	P /C P /C
	OUT		IN	i.LINK IN/OUT
				DV IN
	S VIDEO	IN(L-1)	S VIDEO	S400
REMOTE PAUSE/	AUDIO VIDEO	AUDIO	VIDEO
AV COMPULINK
		IN(L-2)
					(for dubbing)
					[i.LINK IN/OUT]
					i.LINK cable
	Component				(not supplied)
AC Outlet
	Video Output
AC Power			To [i.LINK IN/OUT]
Cord
			OUT		IN	i.LINK IN/OUT
						DV IN
			S VIDEO	IN(L-1)	S VIDEO	S400
						DIGITAL OUT
						OPTICAL
	REMOTE PAUSE/		R AUDIO L VIDEO	R AUDIO L	VIDEO	PCM/DOLBY DIGITAL
	AV COMPULINK
				IN(L-2)

Back of VCR

[AUDIO OUT]

Audio Cable (supplied)

Preparations

— Check contents

Make sure the package contains all of the accessories listed in ‘SPECIFICATIONS’ (
page 59).

— Situate VCR

Place the VCR on a stable, horizontal surface.

i.LINK Connections

1Make connections

— Connect VCR to TV

1Connect an audio cable between the VCR’s

[AUDIO OUT] connectors and the TV’s audio input connectors.

2Connect a component video cable between the VCR’s Component video output terminals and the TV’s Component video input terminals.

NOTE:

If your TV do not have Component video input terminals, connect the S-VIDEO cable between the VCR’s [S VIDEO OUT] terminal and the TV’s S-video input connector.

—Connect VCR to the Digital HD Video Camera (JY-HD10)

Connect an i.LINK cable between the VCR’s [i.LINK IN/OUT] connector and JY-HD10’s

[i.LINK IN/OUT] connector.

— Connect VCR to another VCR (SR-VD400E)

Connect an i.LINK cable between the playback VCR’s [i.LINK IN/OUT] connector and the recording VCR’s [i.LINK IN/OUT] connector.

TV (HD Ready)

Component Video

Cable (not supplied)

Aerial or cable

NOTE:

Depending on the devices equipped with the i.LINK connector which is connected to the VCR, picture noise on this VCR may differ from the noise on the connected devices. It is caused by the difference of the data processing method.

2 Connect VCR to power source Connect the AC power plug to the AC outlet.

3 Final preparation for use Turn on the VCR.

● You can now perform ‘basic playback’ (
page 8) or ‘editing’ (
page 18).

NOTES:

●When connecting VCR to TV with a component video cable, a menu screen will appear on the TV.

●Use the commercially available i.LINK cable (4-pin, S400, below 3 m).

If the cable used is above 3 m, the operation of this VCR is not guaranteed.

●To view the picture of 480i image format on the TV, connect the component video cable to the TV’sY/CB/CR connectors. If your TV uses both the Y/PB/PR and S-video connectors, connect also the S-video or video connectors between the VCR and TV.

●For full identification of the VCR’s rear panel, refer to the Index (
page 56).

●If you cannot see the pictures on the TV screen when you play back a tape, set “TV OUTPUT 1” to the appropriate mode (
page 38).