EN 17
●Turn on the VCR and the TV, and select the AV mode on the TV.
●Set the [VCR/TV/CABLE/DBS] selector on the Remote to [VCR].
Please input a password number when you playback the tape on which the password was set up.
This VCR can check the tape condition during playback (and recording), and realizes the best possible pictures.
[POWER] 1 | [STOP/EJECT | 2 |
(7/0)] |
IN |
+ |
[REW (
)] [FF (
)]
[POWER]
VCR CABLE
TV /DBS
3
1 Load a D-VHS cassette
Make sure the window side is up, the rear label side is facing you and the arrow on the front of the cassette is pointing towards the VCR.
Do not apply too much pressure when inserting.
●The VCR turns on automatically.
●The tape will run for a few seconds while the VCR searches for the tape number. If the tape number is found, it will be shown on the TV screen if “SUPERIMPOSE” is set to “ON” ( page 39).
●The counter is reset automatically, however, it is not completely reset to “0:00:00”.
●If the cassette’s record safety tab has been removed, playback begins automatically.
●The [D-VHS] indicator lights up.
2Start playback
Press [PLAY ( 3 )].
The “Password Please” screen is displayed. The tape is running but the picture will not appear.
Password Please
* * * * *
[OK] [CANCEL]
3
[CANCEL] | 2 |
|
[REW(1)] 
[FF(¡)]
[STOP(7)]
3Input password number
Press the
“Password OK” screen is displayed and becomes to playback screen about 3 seconds.
Password Please 1 2 3 4 5
[OK] [CANCEL]
«
Password OK
3
NOTES:
●Press [CANCEL], when you redo an input from the beginning during a password input.
●If the password is different, “Password NG” will be displayed as and the “Password Please” display again.
To stop playback
Press [STOP ( 7 )] on the Remote or [STOP/EJECT ( 7/0 )] on the front panel.
To rewind the tape (when it is not running)
Press [REW ( 1 )].
To
Press [FF ( ¡ )].
To eject the tape
Press [STOP/EJECT ( 7/0 )] on the front panel when the tape is not running.
●You can also eject the cassette when the VCR is turned off.
To turn off the VCR
Press [POWER].