20 EN | EDITING (cont.) |
S-VHS/VHS Editing
1 Make connections
Refer to
2 Load a cassette
Make sure the record safety tab is intact. If not, cover the hole with adhesive tape before inserting the cassette.
3 Select input location on this VCR
On the front panel:
Press [CHANNEL +] or [–].
On the Remote:
Press [TV/VCR CH +] or [–].
NOTES:
●When using this VCR as the recording VCR, set the video input terminal setting correctly ( page 38).
●When using this VCR as the playback VCR for editing, set “DIGITAL R3” to “OFF” ( page 36).
4Set recording speed
Press [REC SPEED]/[SPEED] to set the recording speed.
Input Source | Selectable Recording Speed | |
(Playback device) | (Recording device: This VCR) | |
|
|
|
Analog | HS, STD, LS3, LS5 | |
input | SP, EP | |
|
|
|
5Select video input terminal
Access the “IN/OUT FUNCTION” screen ( page 38).
When using [S VIDEO] terminal, set “FRONT AUX
When using [VIDEO] terminal, set “FRONT AUX
6 Set “PICTURE CONTROL” to “EDIT” Access the “VIDEO FUNCTION” screen ( page 36).
7Start playback
Press [PLAY ( 3 )] on the connected device.
NOTE:
If the connected device is equipped with a superimpose/OSD disable feature then set it to “OFF” before starting playback.
8 Start recording
On the front panel:
Press [REC ( ¶ )].
On the Remote:
While holding [REC ( ¶ )], press [PLAY ( 3 )].
●If “V. CALIBRATION” is set to “ON” (default setting: page 36), this VCR checks the tape condition for about seven seconds, then starts recording. This means that the first seven seconds of the program will not be recorded. If this is inconvenient for you, follow the steps
below:
1Press [REC ( ¶ )] and [PAUSE ( 8 )] to start Video Calibration.
2Then press [PLAY ( 3 )] to start recording after Video Calibration is complete.
It may be unlawful to record or play back copyrighted material without the consent of the copyright owner.
To pause recording
Press [PAUSE ( 8 )]. To resume recording, press [PLAY ( 3 )].
To stop recording
Press [STOP ( 7 )] on the Remote or [STOP/EJECT ( 7/0 )] on the front panel.
To rewind the tape (when it is not running)
Press [REW ( 1 )].
To
Press [FF ( ¡ )].
To eject the tape
Press [STOP/EJECT ( 7/0 )] on the front panel when the tape is not running.
●You can also eject the cassette when the VCR is turned off.
To turn off the VCR
Press [POWER].
NOTES:
●Be sure to select “AUTO” for “PICTURE CONTROL” (or “NORM” when “V. CALIBRATION” is set to “OFF”) after you finish dubbing the tapes ( page 36).
●It is impossible to perform dubbing properly only with an audio cable. Connect also the video or