JVC SR-VD400E manual 48 EN, Editng

48 EN			TROUBLESHOOTING (cont.)
	EDITNG
	SYMPTOM	POSSIBLE CAUSE			CORRECTIVE ACTION
	1. Recording will not start, and [CASS]	● There is no cassette loaded.		Insert a cassette.
	blinks on the front display panel for	● The loaded cassette has had its record		Remove the cassette and cover the hole
	about 5 seconds.	safety tab removed.		with adhesive tape, or load a cassette
				on which the record safety tab is in-
				tact.
	2. Tape-to-tape editing will not work.	● The components have been incor-		Connect the components correctly
		rectly connected, or correct video		( page 5, 6) or check “REAR AUX L-
		connector ([S VIDEO] or [VIDEO]) is		1 (or L-2)” and “FRONT AUX F-1” set-
		not selected.		ting ( page 38).
		● The power to one or more of the units		Make sure the power to all units is on.
		has not been turned on.
		● The recordingVCR’s input location has		Select the appropriate input location on
		been set incorrectly.		the recording VCR.
	VIDEO NAVIGATION
	SYMPTOM	POSSIBLE CAUSE			CORRECTIVE ACTION
	1. Tape information screen does not ap-	● The current tape inserted has not been		Tape information cannot be shown if it
	pear for the currently inserted tape.	recorded on this VCR.		has not been recorded on this VCR.
	2. The VCR cannot search for the de-	● Two (or more) tape numbers are re-		Video Navigation cannot work correctly
	sired program.	corded on one tape.		on a tape if it has more than one tape
				number. If this happens, fast-forward the
				tape up to its end, eject it, and try it
				again.
		● The inserted program is not recorded		It is impossible to search the desired
		on this VCR.		program which is not recorded on this
				VCR using Video Navigation.
	3. “MEMORY FULL” appears on the	● The VCR’s memory for Video Naviga-		Check	the	remaining	memory
	screen when you try to start record-	tion is fully recorded.		( page 34). If it is full, delete unnec-
	ing.			essary Video Navigation information
				( page 33, 34).
	4. The information data for Video Navi-	● The VCR’s memory for Video Naviga-		Check	the	remaining	memory
	gation is not registered.	tion is fully recorded.		( page 34). If it is full, delete unnec-
				essary Video Navigation information
				( page 33, 34).
		● “NAVIGATION” is set to “OFF”.		Set “NAVIGATION” to			“ON”
				( page 25).
		● The recording time is not enough.		For details on the recording time for
				Video Navigation, refer to ‘NOTES’ on
				page 24.