JVC SR-VD400E manual 38 EN, No Conv

38 EN			OTHER USEFUL FUNCTIONS (cont.)
Input/Output settings “IN/OUT FUNCTION”			* The default setting is bold in the table below.
“TV OUTPUT 1”	Select the appropriate mode when receiving signals via i.LINK connector or playing
“720to1080”	back a D-VHS tape containing a recording of an HD (High Definition) signal:
“NO CONV.”
“ALLto480i”	“720to1080” : 720p is up-converted to 1080i and output to the TV. 1080i, 480p,
		and 480i image formats are output to the TV without being
		converted. Select this when the 720p image played back is
		distorted.
	“NO CONV.”	: 1080i, 720p, 480p, and 480i image formats are output to the TV
		just as they are.
	“ALLto480i”	: All images will be output to the TV in 480i image format.
	NOTE:
	When you receive signals via i.LINK connector or play back the picture of 1080i,
	720p, 480p image format, the signal is not output from the S-VIDEO or VIDEO
	output connector if “TV OUTPUT 1” is set to “720to1080” or “NO CONV.”.
“TV OUTPUT 2”	Select the appropriate mode depending on the type of TV you have.
“WIDE 16:9”	“WIDE 16:9” : Select this for a wide TV set with 16:9 screen image size.
“NORMAL 4:3”	“NORMAL 4:3” : Select this for a TV set with 4:3 screen image size.
	NOTES:
	● When “TV OUTPUT 2” is set to “WIDE 16:9”, sometimes the screen image may
	be stretched vertically.
	● When “TV OUTPUT 2” is set to “NORMAL 4:3”, sometimes subtitles may not be
	visible or the ends of the screen image may be cut off. Normally select “WIDE16:9”.
	● In order to let the equipment determine the screen image size, it is recommended
	that you connect the VCR and TV using the component video output connectors
	or [S VIDEO OUT] connector.
“FRONT AUX F-1”	You have to select which terminal — either [VIDEO] (composite) or [S-VIDEO] (Y/C
“VIDEO”	separate signals) to use as the video input terminal on the front panel.
“S-VIDEO”	Make sure to select the correct terminal; otherwise, you may fail in recording (editing)
	on this VCR.
“REAR AUX L-1”	You have to select which terminal — either [VIDEO] (composite) or [S VIDEO] (Y/C
“VIDEO”	separate signals) to use as the video input terminal [L-1] on the rear panel.
“S-VIDEO”	Make sure to select the correct terminal; otherwise, you may fail in recording (editing)
	on this VCR.
“REAR AUX L-2”	You have to select which terminal — either [VIDEO] (composite) or [S VIDEO] (Y/C
“VIDEO”	separate signals) to use as the video input terminal [L-2] on the rear panel.
“S-VIDEO”	Make sure to select the correct terminal; otherwise, you may fail in recording (editing)
	on this VCR.