Chapter 2
Parts of the System
Current Remote Control Address:
New Remote Control Address:
CHANGING THE REMOTE CONTROL ADDRESS
The remote control and receiver can operate on any one of 16 addresses; however, they must both be on the same address for the remote to control the receiver. This section explains how to change the address in both devices.
Note: Do not change the address of the remote unless absolutely necessary because the remote cannot control the receiver if the two devices have different addresses.
1.Turn the receiver OFF and press either CHANNEL UP or DOWN on the front panel to display the Important System Information screen. Note the current Remote Address shown on your TV screen.
2.Press and hold the SAT mode button until all the mode button backlights come on (it takes about three seconds). Release the SAT mode button.
3.Use the number buttons to enter a new number from 1 to 16. Write the new address in the space provided.
4.Press the POUND button. If the address you entered is valid for the remote control, the SAT mode button backlight flashes three times.
5.Point the remote at the receiver and press the RECORD button. The Remote Address on the Important System Information screen should match the one you entered.
Note: If the Remote Address does not change on the Important System Information screen, press the RECORD button again.
6.To check the address programmed in the remote, press and hold the SAT mode button for three seconds. Then press the POUND button twice. The SAT mode button backlight flashes the same number of times as the address.
7.Press the SELECT button to exit the Important System Information screen.
Page 10