Chapter 3
Using the System
4.Select the VCR Setup option.
5.Find the brand name of the VCR in the table on page 66.
6.Set the code for the VCR using one of the following:
•Enter the first
NUMBER PAD buttons.
•Highlight each digit of the first VCR code, and then press the UP or DOWN ARROW button until you reach the correct number and then press
SELECT.
7.Make sure the VCR is turned ON and the switch is set to 3 or 4 (whichever you use). Insert a rewound tape on which you want to record. The receiver starts the VCR recording, but does not turn ON the VCR, so you must do this yourself.
8.To test the new code, highlight the Test option. The receiver displays a message warning you to make sure the VCR is turned ON.
9.Press the SELECT button to start the test. Your VCR records for a few seconds, stops, and then rewinds. The receiver displays a message saying that your VCR test is complete. Follow the instructions on the message.
10.If your VCR did not complete the test, enter another code from the table, and then repeat steps 5 through 8.
11.Once you have found the correct VCR code select the Save option to save the VCR code you entered and return to the Installation and Setup menu.
USING LOCKS
First you set the locks; then you lock the receiver. You must lock the receiver in order to put any locks into effect. If you unlock the receiver, leave the locks unchanged, and then lock the receiver again, the same locks will be in effect as before.
HOW TO SET LOCKS: A TWO STEP PROCESS
1.Create the locks that you want.
2.Lock the receiver.
Once the receiver is locked, anyone who wants to access locked items must enter the password.
Page 42