Kathrein UFD 520 manual Command of the remote control, Receiver on the command set

Command of the remote control

	The remote control features 2 command sets, making it possible to operate
	2 receivers independently of each other in one room (not together with a twin
	receiver).
Note	For this purpose, program one receiver on the command set 1 and the second
	receiver on the command set 2.
	￿￿Switch on receiver 1 and receiver 2 off with the power switch
	￿￿Press and hold the ￿￿button.
	￿￿Enter "901" with the number buttons.
	￿￿To adopt the code, press the ￿￿button to switch receiver 1 to standby and
	then switch off the device with the power switch.
	￿￿Switch on receiver 2.
	￿￿Press and hold the ￿￿button.
	￿￿Enter "902" with the number buttons.
	￿￿To adopt the code, press the ￿￿button to switch receiver 2 to standby and
	then back into operation. Now switch on receiver 1 again.
	￿￿Press and hold the ￿￿button.
Note	￿￿Enter "903" with the number buttons.
	When carrying out the first two settings, the remote control must be directed at the
	respective receiver (when switched on).
	By pressing the ￿￿button, you can now switch between the two command sets A
	and B (toggle function) and alternately operate both receivers.
	Command set 1 is always active as the on-delivery setting.
Note	If you are operating only one receiver and the active command set is switched over
	by mistake so that this receiver can no longer be operated, the remote control can
	be easily switched back to command set 1. For this purpose, follow the procedure
	described above.

11