On screen displays
Important screen displays
The receiver functions are controlled by a microprocessor and extensive software. The following explanations are intended to improve understanding of all proce- dures and to minimise the risk of mistakes.
TV channel identifier
The channel identifier is displayed for several seconds every time the channel is
changed or by pressing the button.
The I indicates that a channel is received
even if no picture can be seen (e.g.
radio). The film symbol indicates a TV channel with the selected programme shown next to it and whether teletext is received. The current time, start time and end time of the current programme are shown on the next line provided these data are transmitted. The + in the third line stands for the programme selection from the main programme list. If the favourite list is selected, you will see the "apple" symbol at this point. This is followed by the set sound reproduction mode (depending on the direction of the symbolised sound waves, mono left, mono right or stereo can be set, the digit indicates the number of sound channels). The programme title is shown in the box on the right.
Radio channel indicator
The identifier for the set radio channel has the same configuration. A music note appears in the upper
the signal.
Error message
TV programme list
"Bad or no signal" indicates that there is a fault in the reception system or in the re- ceiver settings or the transponder is not
transmitting. Instead of the I the channel
identifier shows a satellite antenna together with the message "bad or no signal". Check the
service settings provided at the end of this User's Guide.
Press the button to show the programme list. A + for the main programme list or the "apple" symbol is indicated at the top left. The list can be changed by pressing the button again. Information relating to the received satellites, transponder and its frequency, the polarisation, the symbol rate, scrambling, favourite or standard programme and the parental control is
17