Kathrein UFD 520 manual Pre-programming is not deleted with Reset

Page 43

Installation menu

A remote frequency must not be set in this operating mode, because it is defined by the UFO micro system as part of the addressing procedure.

You will need to delete the previously allocated address when using the receiver for the first time together with a UFOmicro receiving system. You can do this under

the UFOmicro menu point by selecting "Reset" with the buttons and pressing

.

The original factory setting is then allocated to the receiver. It must then be reset to ON. The receiver will then receive a new address from the new system.

The pre-programming is not deleted with "Reset".

Preset: OFF

Factory setting

Under this menu point, you can reset all the settings to the factory setting by press- ing .

The factory settings need not necessarily correspond to the settings required for your system!

After the reset, it may be necessary to repeat all settings.

43

Image 43

Contents Operating Manual Page Important Notes PrefaceContents Oscillator frequency L.O Changing the oscillator frequency Transponder selection Safety instructions Mains voltage Place of installationVentilation Humidity, exposure to sunlight, heatView of front panel Controls, displays and connectionsView of rear panel Remote control handset keys Receiver on the command set Command of the remote controlAlphanumeric entries Operating instructionsMenu concept Button functionsLanguage selection OSD Sat if connection Presetting receiving systemConnection and start-up To connect receiverAudio connection Inserting batteries in the remote controlLNB-supply voltage TV and video recorder connectionFactory setting of receiver First time installationFirst steps Important screen displays Radio channel indicatorError message TV programme list On screen displaysRadio programme list Selecting a TV programme Programme selectionReception status digital Reception status analogue Switching over to radio programmeSelecting a radio programme by number entry Reception status radioVPS-Signal Timer settingsMute Sound settingsSetting the volume Stereo and two-channel sound reproductionSelecting TV/radio programmes last received Programme list TV/radioFavourite programmes To delete a programme Programme assortmentTo add a programme manually Analogue programme list To add analogue programmesAdding/removing satellites Setting up a satelliteTo remove a satellite To enter a satellite nameProgramme overview EPG timer programmingFull EPG Parental lock PasswordFactory setting Entering a passwordPassword Backup operation System parameters Setting system parametersScreen Summer timeTV type Picture formatOSD trans Oscillator frequency L.O LNB configurationChanging the oscillator frequency Installation menuAntenna settings DiSEqC settingSatellite search Transponder selection TP set-up/searchAll new programmes are added to the existing programme list DiSEqC UFO Set-upHigh/Low Pre-programming is not deleted with Reset Video menu Analogue settingDecoder HDP ModeAudio mode Audio menuBandwidth Frequency left/rightDe-emphasis Recording Video recorder connectionPlayback Path must be set to external refer to section Video menu Analogue decoder connection„Display info Software and programme lists updateTransferring operating software Data transfer from receiver to receiverPreparation Transferring programme listsTechnical annex Technical featuresTechnical data Switchover VHS/S-VHS AccessoriesScart socket assignments Connection arrangement Connection examplesBrückeund DVB Glossary, abbreviationsAC3 Short technical lexiconShort technical lexicon Satellite ServiceDiSEqC menu 998.6248/1001/ZWT Subject to technical modifications