Kathrein UFD 520 DiSEqC UFO Set-up, All new programmes are added to the existing programme list

Installation menu

After an unsuccessful search the following message appears:

Error

All new programmes are added to the existing programme list.

Under the menu item „Delete TP,“ you can remove the transponder from the pro-

gramme memory by pressing ￿. You will be requested to confirm that you wish to remove the transponder before it is deleted.

DiSEqC (UFO) Set-up

You should only make changes in this menu when the receiver is to be connected to another receiving system with different features or if changes have been made to the receiving system.

Therefore, take particular note of the information relating to your Sat-IF system. Be- fore making any changes, you should make a note of these settings on the form provided at the end of this User's Guide.

Press the menu buttons ￿, ￿￿and ￿to open the DiSEqC menu.

22-kHz signal

In this menu point you can determine whether the 22 kHz signal is to be used to switch over between the low and high frequency range of a satellite or between 2 satellite positions.

Tone burst and DiSEqC signal

A DiSEqC control signal is necessary if more than four control criteria are required in a receiving system.

Which of the setting options, i.e. tone burst or DiSEqC, is required depends on the components of the receiving system.

Therefore refer to the description of the components (switchover matrices) of the receiving system.

41