Kathrein UFD 520 manual Safety instructions

Page 7

Safety instructions

Important notes regarding operation

The following section contains important information relating to the operation, place of installation and connecting-up of the receiver.

Read these notes carefully before putting the unit into operation.

Extended absence / thunderstorms

Always switch the unit off via its mains switch (at front left on unit) during periods of extended absence or at the onset of thunderstorms. This also applies to any other equipment that is connected to the receiver.

However, take into account any possible timer programming and switch the unit on again in good time prior to the recording time.

Mains lead

Make certain that the mains lead (power supply lead) is undamaged. Never put the unit into operation if the mains lead is damaged.

Cleaning

Withdraw the mains plug before cleaning the unit. Use a dry cloth for cleaning. Clean the surface only and nothing else.

On no account open the housing. There is a risk of electric shock if components within the unit are touched.

Children-at-play

Pay attention that children do not insert objects into the ventilation slots. There is a risk of mortal danger due to electric shock.

Repairs

If your receiver needs repairing or changes to settings, get qualified specialists to carry this out. Unauthorised opening and attempts at repairs entail loss of guaran- tee.

The unit’s electrical safety can be affected by improper tampering with it.

The manufacturer’s liability excludes accidents occurring to the user when the unit is opened.

Connections

The unit may be rendered inoperative or not work properly if the connections are not wired up properly.

7

Image 7
Contents Operating Manual Page Important Notes PrefaceContents Oscillator frequency L.O Changing the oscillator frequency Transponder selection Safety instructions Mains voltage Place of installationVentilation Humidity, exposure to sunlight, heatView of front panel Controls, displays and connectionsView of rear panel Remote control handset keys Receiver on the command set Command of the remote controlAlphanumeric entries Operating instructionsMenu concept Button functionsLanguage selection OSD Sat if connection Presetting receiving systemConnection and start-up To connect receiverAudio connection Inserting batteries in the remote controlLNB-supply voltage TV and video recorder connectionFactory setting of receiver First time installationFirst steps Important screen displays Radio channel indicatorError message TV programme list On screen displaysRadio programme list Selecting a TV programme Programme selectionReception status digital Reception status analogue Switching over to radio programmeSelecting a radio programme by number entry Reception status radioVPS-Signal Timer settingsMute Sound settingsSetting the volume Stereo and two-channel sound reproductionSelecting TV/radio programmes last received Programme list TV/radioFavourite programmes To delete a programme Programme assortmentTo add a programme manually Analogue programme list To add analogue programmesAdding/removing satellites Setting up a satelliteTo remove a satellite To enter a satellite nameProgramme overview EPG timer programmingFull EPG Parental lock PasswordFactory setting Entering a passwordPassword Backup operation System parameters Setting system parametersScreen Summer timeTV type Picture formatOSD trans Oscillator frequency L.O LNB configurationChanging the oscillator frequency Installation menuAntenna settings DiSEqC settingSatellite search Transponder selection TP set-up/searchAll new programmes are added to the existing programme list DiSEqC UFO Set-upHigh/Low Pre-programming is not deleted with Reset Video menu Analogue settingDecoder HDP ModeAudio mode Audio menuBandwidth Frequency left/rightDe-emphasis Recording Video recorder connectionPlayback Path must be set to external refer to section Video menu Analogue decoder connection„Display info Software and programme lists updateTransferring operating software Data transfer from receiver to receiverPreparation Transferring programme listsTechnical annex Technical featuresTechnical data Switchover VHS/S-VHS AccessoriesScart socket assignments Connection arrangement Connection examplesBrückeund DVB Glossary, abbreviationsAC3 Short technical lexiconShort technical lexicon Satellite ServiceDiSEqC menu 998.6248/1001/ZWT Subject to technical modifications