Using the CR-314 remote control

CD/DVD

0–9 keypad

Ensure that DVD mode is selected using the CD/DVD

This allows direct access to individual tracks on audio CDs.To select

toggle button.The ‘DVD’ LED above the CD/DVD button is

a track, press the corresponding keypad button followed by OK.

lit briefly when DVD mode is selected.

For tracks greater than 9, enter the digits in sequence. For example,

to play track 15, press 1, then 5, then OK.

Standby

DISP (display)

Press STANDBY to toggle the standby state of the DVD player.

Dims or turns the DV27A’s display on or off.Turning the display

CD/DVD REMOTE

Note that Arcam CD players are not controlled by this button.

off generally gives a slight improvement in sound quality.

DVD

CLEAR

Pressing DISP once turns the display off; twice dims the display.

Use CLEAR within the ‘Program’ and ‘Bookmark’ menus to clear

To restore the display to full brightness, press DISP a third time.

a numeric field (see pages 15–16).

DVD

A–B

PROG (program)

This button enables you to repeat a selected

DISP

You can program a selection of up to 20 chapters/tracks from

section from the disc (see page 16).

a disc to play in any order. Press PROG to access the ’Program’

A-B

RPT (repeat)

menu (see page 16 and 17).

RPT

CLEAR

PROG

Press RPT to cycle through the repeat play options;

alternatively use the ‘Play modes’ menu.

Page Up/Down (DVD-audio)/Slow play (other discs)

Fast play and Skip chapter/tracks

DVD-audio: Some DVD-audio discs all the user to browse

through images (photographs of the artist, lyrics, etc.) while

Play fast (

) and Skip (

) chapters/tracks in both

directions (see page 6).

music is being played. Use the or buttons to change to the

previous/next page. Note that this is not availble on all DVD-

OPEN

audio discs.

OPEN

Opens and closes the disc tray.

Other discs: Press or on the remote control to play slow

forward or backwards.There are four speeds of slow playback:

1/5, 1/4, 1/3 and 1/2. Press the button repeatedly to cycle

through the different speeds.To resume normal playback speed,

Cursor pad and OK button

press PLAY.

Use the cursor pad to navigate the On Screen Display (OSD)

NOTE: Slow play does not apply to audio CDs or DVD-audio discs.

and menu pages. Confirm your selection with the OK button.

Playback control

Pause (), Play () and Stop () (see page 6).

MUTE

Stops sound to the speaker outputs of certain Arcam amplifiers.

Volume +/–

Adjusts the volume on Arcam remote-controllable amplifiers.

Note that the volume (+/–) controls and MUTE button have no effect on the audio output level of the DVD players.

Advanced controls

These buttons are described on the next page.

P	SUBT	TITLE	MENU
MODE

ZOOM AUDIO MEM RTN

ANGLE SETUP STATUS SRCH

CR-314

NOTE: Remember to install the two AAA batteries supplied before trying to use your remote control.

Do not place anything in front of the FMJ badge on the left of the front panel (where the IR receiver is located), or the remote control may not work.