Using the CR-415 remote control
|
|
|
| |
|
|
| This allows direct access to individual tracks on audio CDs.To select | |
OPEN | a track, press the corresponding keypad button followed by OK. For | |||
|
|
| tracks greater than 9, enter the digits in sequence. For example, to | |
Opens and closes the disc tray | ||||
|
|
| play track 15, press 1, then 5, then OK. | |
DISP (display) |
| Standby | |||
|
|
|
|
| |
|
|
| Press STANDBY to toggle the standby state of the DVD player. | ||
Dims or turns the player’s display on or off.Turning the display off | |||||
DVD | |||||
generally gives a slight improvement in sound quality. | |||||
|
|
| |||
Pressing DISP once turns the display off; twice dims the display.To |
|
|
|
|
|
|
|
|
|
|
|
| CLEAR |
| |||
restore the display to full brightness, press DISP a third time. |
|
|
|
|
|
|
|
|
|
|
|
| Use CLEAR within the ‘Program’ and ‘Bookmark’ menus to | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| clear a numeric field (see pages | ||
|
|
|
|
|
| OPEN | 1 | 2 | 3 |
|
| ||||||
|
|
|
|
|
|
|
|
|
|
| |||||||
|
|
|
| DISP | 4 | 5 | 6 |
|
| PROG (program) | |||||||
|
|
|
|
|
|
|
| ||||||||||
This button enables you to repeat a selected |
|
|
|
| |||||||||||||
|
|
|
|
|
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
section from the disc (see page 16). |
|
|
| 7 | 8 | 9 |
|
| You can program a selection of up to 20 chapters/tracks | ||||||||
|
|
|
|
|
|
|
| from a disc to play in any order. Press PROG to access the | |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
RPT (repeat) |
|
|
|
|
|
|
|
|
|
|
|
| ‘Programme’ menu (see pages 15 and 16). | ||||
|
|
| RPT |
| CLEAR | 0 | PROG |
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
| ||||||
Press RPT to cycle through the repeat play options. |
|
|
|
|
|
|
| ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
Fast play and Skip chapter/tracks
Play fast (
) and Skip ( 
) chapters/tracks in both directions (see page 6).
SETUP
‘Setup’ allows you to configure the DVD player for use in your system. Ensure that no disc is playing and press SETUP to access the ‘Setup’ menu.
Cursor pad and OK button
Use the cursor pad to navigate the On Screen Display (OSD) and menu pages. Confirm your selection with the OK button.
Playback control
Pause (
), Play (
) and Stop (
) (see page 6).
Advanced controls
These buttons are described on the next page.
|
| Page Up/Down | ||||
|
| |||||
|
| through images (photographs of the artist, lyrics, etc.) while | ||||
|
| music is being played. Use the | or | buttons to change to | ||
|
| the previous/next page. Note that this is not availble on all | ||||
SETUP | MENU |
|
|
|
| |
|
| Other discs: Press | or | on the remote control to play slow | ||
|
| forward or backwards.There are four speeds of slow playback: | ||||
|
| 1/5, 1/4, 1/3 and 1/2. Press the button repeatedly to cycle | ||||
| OK | through the different speeds.To resume normal playback | ||||
|
| speed, press PLAY. |
|
|
|
|
|
| NOTE: Slow play does not apply to audio CDs or | ||||
|
| discs. |
|
|
|
|
|
| MENU |
|
|
|
|
|
| Press MENU to access the DVD ‘Disc’ menu. | ||||
This navigation menu is specific to a disc and varies for each title, but typically offers facilities to select chapters, languages, and view extra material such as trailers or documentaries.
|
|
|
|
| Once the menu has been accessed, use the cursor pad to |
|
|
|
|
| move around the menu and press OK to activate a menu |
| AUDIO TRIM | TITLE | RTN | ‘button’. | |
|
|
|
|
|
|
ZOOM | ANGLE | SUBT | PL | MUTE | |
Stops sound to the speaker outputs of certain Arcam | |||||
|
|
|
| ||
P | STATUS | MEM | SRCH | amplifiers. | |
MODE |
|
Volume +/–
Adjusts the volume on Arcam
Note that the volume
NOTE: Remember to install the two AAA batteries supplied before trying to use your remote control.
Do not place anything in front of the display area on the DVD player (where the IR receiver is located), or the remote control may not work.
14