Samsung DTB-D700F Operating the Receiver, Teletext OSD, Teletext VBI, Audio Mode, Manual Scanning

DTB-D700F

BASIC FUNCTIONS (DTT)

8. Teletext OSD

When the current broadcasting program provides Teletext OSD, press the TEXT key twice to see the current Teletext OSD list.

To change the Teletext OSD:

●Use the
/  keys to select a Teletext OSD you want.

●Press the OK key and then the Teletext OSD you want is displayed on the screen.

9. Teletext VBI

When the current broadcasting program provides Teletext VBI, press the TEXT key three times to see the current Teletext VBI list.

To change the Teletext VBI:

●Use the
/  keys to select a Teletext VBI you want.

●Press the OK key and then the Teletext VBI you want is displayed on the screen.

Note : A television with TV functions supported shall be used. The system shall operate with the subtitle turned off.

10. Audio Mode

You can choose a mode among left, right or stereo using the AUDIO key.

To change the audio mode:

●Press the AUDIO key to select the left, right or stereo.

●Press the EXIT key to save and escape from this menu.

GB-20

2. OPERATING THE RECEIVER

Main Menu

After installing your antenna system and DTB-D700F with appropriate connectors.

●Plug in the AC main power and switch on the receiver.

●Press the MENU key to bring up the main menu.

The following on screen display will appear:

The sub menu topics will be displayed.

For the sub-menus Installation, Channel Organising and

Parental Lock you need the PIN Code.

2.1. Installation

This menu consists of 3 sub-menus:

Manual Scanning, Auto Scanning and Reset to Factory Default.

●Select “Installation” in the main menu mode to select the sub menu.

●Enter the PIN Code.

If you have not entered your own PIN Code then the

PIN Code 0000 applies, which was set at the factory.

2.1.1 Manual Scanning

To tune-in new channels and weak signals, the DTB-D700F has been provided with the option “Manual Scanning” where the channel data can be entered by the user.

After selecting the “Manual Scanning” from the Installation Menu, the following screen will be displayed:

●Select the channel which you want to find.

●Input the frequency of the channel you want to find.

●Select the bandwidth.

You can select the value of 6, 7 or 8 MHz.

●Select the FFT (Fast Fourier Transform) Mode. You can select the value of 2K or 8K.

●After select option, press the OK key to start the scanning process.

D T T R E C E I V E R / D V D P L A Y E R GB-21

DTB-D700F

GB