GE 0150-0193G manual Main Menu → Alarms → Archive Alarms, Main Menu → Macro → Macro Record

	TCP/IP Notification Setup
One or more of these	Notify Vidloss:	DISABLE
fields must be set to	Notify Alarm:	DISABLE
ENABLE to receive an	Notify Record:	DISABLE
email notification of
the selected event.	Notify Archive:	DISABLE
	Notify Menu Access:	DISABLE
	Notify Power Up:	DISABLE
	Notify Connection:	DISABLE
The IP Addresses	Primary Host:	0.	0.	0.	0
	Backup Host:	0.	0.	0.	0
of the PC on which
the WaveReader	Port:	1027
Software resides	Notification Interval (minutes): Immediate
	[CANCEL]	[OK]

The Notification Interval can be set from 1 minute to 60 minutes, or immediately upon the event.

qMain Menu → Alarms → Archive Alarms

Selecting Enable from this menu will cause the unit to activate Relay 2 if a malfunction occurs while archiving.

Archive Alarm

Relay 2

ENABLE

3.12 Macro

A macro is a recorded sequence of keystrokes. The number of macros depends on the number of camera inputs (4, 10 or 16). Each macro can have up to 32 keystrokes.

Use this menu to:

∙Enter Macro Record mode.

∙Program a scheduled start time for a macro.

∙Edit the RS232 command string for each submacro.

Macro Record

Timed Macro Start

Edit Submacro

qMain Menu → Macro → Macro Record

Note: Do not attempt macro programming while the front panel is locked.

To begin recording a macro:

1.Select the macro number you wish to record, then press the Enter button. The unit will automatically exit the menu system and go to a starting point. Macro Record mode

is indicated as F and the Macro Number on-screen.

Macro Record

Select Macro

01

2.From this point, begin recording the desired keystroke sequence. Record up to 32 keystrokes. If 32 keystrokes are exceeded, the unit will end the macro recording automatically.

3.When finished programming, press the Function button then the Enter button to end the macro recording. A form is provided in section 10 to keep track of recorded macro functions.

0150-0193G 47 DVMRe Triplex