GE 0150-0193G manual DVMRe Triplex WaveLink, Functionality, Name Code Description Example

6.2 DVMRe Triplex WaveLink

A new feature with Triplex software version 5.00 is the DVMRe Triplex WaveLink. This feature allows putting command codes in the URL when calling WaveBrowser to control actions the WaveBrowser is going to perform.

This feature can be used by Web Developers to link various cameras to specific Web content. It will also be used by the DVMRe Email feature to allow the recipient of an alarm email to click on a link in the email, which causes the WaveBrowser to connect and play back at the time when the alarm occurred.

Functionality

The traditional WaveBrowser URL is http://<IP_Address>/wrcontrollite.ssi. This URL will start the WaveBrowser in the disconnected state. Triplex software version 5.00 supports command codes placed after an underscore after wrcontrollite and before .ssi. In the following example, the options are in bold.

Example: http://3.18.172.230/wrcontrollite_c=1s=2a=3t=1361959858.ssi.

The following table specifies the supported options:

Name	Code	Description		Example
Camera	c=<n>	Describes either the camera number for		c=10
		fullscreen (1=Camera 1, …16=Camera
		16) or the type of the multiscreen display
		(100 = Multiscreen 16 large, 101=
		Multiscreen 16 small, 102= Quad
		screen)
Size	s=<n>	For fullscreen camera, describes the		s=2
		size of the display (1=large, 2 =medium,
		3= small)
Action	a=<n>	Describes the action the WaveBrowser		a=2
		has to take:
		0	No action
		1	Normal Connection Play
		2	Normal Connection Live
		3	Normal Connection Goto
		4	Live Connection
Time	t=<n>	When action is set to 3 (Goto), the time		t=1361959858
		specifies where to go in number of
		seconds since 01/01/1960.

NOTE

Please Note: When an option is not specified, it will be set to 0.

When a normal connection is requested, but the DVMRe unit is already connected via a normal connection, the WaveBrowser should open a live connection instead.

0150-0193G 81 DVMRe Triplex