AVE MV DR4000 manual Mobile Rack HDD Installation

Page 52

6.

6. Secure the driver in the rack using two mounting screws in both the side-mounting holes. Please don’t tighten the screws too much, otherwise that may damage the driver.

7.	8.	7.	Screw the rack into the device,
		7.	Screw the rack into the device,
			screwing in all the four screws.
		8.	Attach the interface connector and the
			power connector to the drive. Please

note the red lining of the IDE cable and the red wire of power cable must line up side by side.

10.

Place the mobile rack back onto the device and screw it in.

7.2Mobile Rack HDD Installation

1.Make sure that the key unlocked.

2.Pull the active-handle outward to remove the carrier body away from the mobile rack

50

Image 52

Contents AVE Page Safety Precautions Table Of Contents IDE Hard Disk Installation Product Features Product IntroductionHard-disk drive compartment Front ViewHard disk compartment lock Rec Indicator Disk IndicatorDisplay button Up / Down CH2 / CH1 buttonsJog Dial Mobile Rack Power LEDMobile Rack HDD LED Rear View Between 75Ω and Hi-ZThis Figure is Looked from the Rear View Alarm In/OutRecord in Input This pin Basic Connection Connecting with 1 to 4 CamerasAttaching AN External Device to DVR Seagate Hard-Disk Drive InstallationMaxtor 09- 05-2003 System Information and channel selectionSystem Information Quality Best Ntsc Rate 6 HR Size POSUpdating System Software Configuring Recording Settings Ntsc Audio OFFNtsc Audio on PAL Audio OFFPAL Audio on Recording Operations Timer RecordingManual Recording Start END 0000-0000 M 0000-0000 W 0000-0000 0000-0000 0000-0000 0000-0000 0000-0000 0000-0000Alarm / Motion Recording PRE- Alarm OFF Motion Setting Main Alarm REC EnableAlarm / Motion ALM Operation REC Rate REC Quality Best Audio OFF ALM Type ALM DurationExternally triggered Recording BelowOperation Status From REC mode to Playback mode Playback OperationsFast Forward/Reverse Search to play back a particular recorded videoPlayback Picture-by-picture Slow Forward/ ReversePlay Back Recorded Video from a HDD of the mobile rack Search Operations Search Full List Alarm List Time Search Thumbnail SD CardFull List Search Alarm list Search Time SearchSD Card Search Thumbnail SearchMM DD Year 03 / 13 Backup Operations Mobile Rack HD Backup OperationsSet HD 2 to Backup first. Take the following steps F0000.JPG F0001.JPG F0002.JPG F0003.JPG F0004.JPG F0005.JPGFull Select Duplicate a particular recorded video from HD1 to HD2Disk Setting Reformat HD2 Usage Security Digital Card SD Card Backup OperationsSave to F0000.JPG Save to F0001.JPG Save to F000N.JPG For more detail Backup the System setting info into SD Card Save the whole setting into the SD cardTransfer the system setting info of DVR to another Archive video of AVI Clips into SD CardKey Lock Operation Set Up Menu Navigation Buttons Setup button Enter buttonREC Setting REC QualityAlarm / Motion Setting ALM Type PRE- Alarm 0600-1600 1200-1800 REC Schedule0600-1800 0000-0000 Channel 1 2 3 Dwell 03 03 03 03 TitleNET Enable OFF NET Dhcp NET IP SET FTP Setting Main NET EnableHttp Port FTP Setting Comm Setting Comm ID1 S Account SET Main SET FTP on / OFFAccount FTP Account FTP IPUser PathBackup HD HD2 Usage HD 1System Situation MAC 00 0c 0c 00 00 Bios Date Mar 10 General Command Format SetupCommunication Protocol Value of a specific front panel key DEC HEXRequest Time Second Category=0x02 Set Time Second Category=0x02REC Mode Non REC ModeDVR Playback Error Request State Second Category=0x06Jumper settings of hard-disk drives for the system Location Built-in hard diskMobile Rack HDD Installation Page Page System Default Disk Setting Reformat SET RS232 / RS485D. Message Meanings Network Viewer PIN noInstall the Network Viewer for the ZIP file View the 4CH DVR video from a remote PC Page Function Buttons Description Page Change the Record & Timer Properties Via the Network Set the regular record settingsSet the Alarm record settings Set the Record ScheduleArchive Images to the Computer Image Viewer 12-02-02 01-30-03 Lists 2999 02-03-03 3000 02-08-03 Point stops recording Previously recorded data remainingPhysical specification of RJ-45 cable for Ethernet Cable ConnectionsConnect to a computer Connect to a LAN Hub IntranetRJ-45 PIN configuration for LAN Hub Configure Your DVR Network SettingsEnable DVR Network Function Connect to WAN InternetEnable Dhcp Function Set IP AddressPage 12.3 TCP/IP Communication Software 12.4 TCP/IP installation 12.5 TCP/IP Configuration setting Click Start Settings Control Panel NetworkConnection Testing Click Start ProgramsPage Connecting the 4CH DVR Description of functional keysBrowsing images from the 4CH DVR Page Change Record / Alarm Setting Change Timer Record Setting Change Pan/Tilt/Zoom Setting Page Design and specifications subject to change without notice Model Number MV-DR4000Appendix 1. -SCANIP