SBCRU258_v1.qxd 24-08-2004 13:30 Pagina 5
Instructions for use
Automatically setting the remote control
If you cannot find the right code for your brand device, the remote control can automatically search for the right code.
Example of TV:
1Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1).
The RU258 emits the ‘switch off TV’ signal for all models of TV that are stored in the memory.
•If the device is a
2Then keep keys 1 and 3 on the RU258
pressed simultaneously for three seconds, until the green indicator light remains lit.
English
3Press the Standby key of the RU258 briefly.
–The RU258 now starts emitting all known ‘TV off ’ signals, one by one. Each time a code is sent, the green indicator
light flashes.
4When your TV switches off
you press the Standby key of the RU258 twice within 1 second, to confirm.
– The RU258 has now found a code that works on your TV.
5 Check if you can operate all functions on your TV with the RU258.
•If this is not the case, you can redo the automatic setting.The RU258 will then search for a code that perhaps works better.
–After the RU258 has run through all the known codes, the search will stop automatically and the green light will stop flashing.
–Automatic programming takes a maximum of 8 minutes for TV,
4 minutes for VCR, 5 minutes for SAT and CBL (Satellite box/Cable box) and 4 minutes for DVD.
5