SRU252_V4_Transfer_RR:SRU252_V4_Transfer 26-03-10 15:32 Pagina
5
•If the device does not respond at all, or not to all of the key commands, start again from step 2 and try the next code from the list.
Automatically setting the remote control
If you cannot find the right code for your brand device, the remote control can automatically search for the right code.
Example of TV:
1Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1).
The RU 252 emits the ‘switch off TV’ signal for all models of TV that are stored in the memory.
•If the device is a
2 Then keep the TV Key pressed for
3 seconds until the green indicator light remains lit.
3 Press the Standby key and keep it pressed.
–The RU 252 now starts emitting all known ‘TV off’ signals, one by one. Each time a code is sent, the 
green indicator light flashes.
Installing the remote control English
4 When your TV switches off 
the Standby key of the RU 252.
– The RU 252 has now found a code that works on your TV.
5 Check if you can operate all functions on your TV with the RU 252.
•If this is not the case, you can redo the automatic setting.The RU 252 will then search for a code that perhaps works better.
–After the RU 252 has run through all the known codes, the search will stop automatically and the green light will stop flashing.
–Automatic programming of a TV takes a maximum of 5 minutes. For VCR/DVD this time is 6 minutes.
EN 5