Dynacord Comprehensive Guide to the DSP 244 Stereo Equalizer Control Settings

Page 41

O P T I O N

CNTCT: 1

Here you are able to select the control input (1 - 8) for programming.

PGM: U01

In this case, the selected control input is used for program change commands. You are able to select user-programs U01 to U30 or factory-presets F01 to F50.

PGM: Mute

This setting allows to use the selected control input for Soft-Mute. Upon closing of the corresponding contact, the DSP 244 outputs are muted - upon opening, the signal is “softly” switched on again. The “Mute” parameter is listed at the end of the program chart, after F50.

9.11 NRS 90247 RS-485 INTERFACE SETTINGS

Amongst other available options, retrofitting the NRS 90247, RS-485 interface in the DSP 244 instead of the RS-232 interface is possible as well. The RS-485 interface allows configuring, controlling and monitoring up to 31 DSP 244 from a PC. In that case, assigning individual RS-485 IDs to each DSP 244 is necessary.

The Group-ID can only be edited via the PC-software. RS-485 IDs are set in the following menu.

9.12 DISPLAY OF THE SOFTWARE REVISION NUMBER

The display shows the software revision of the DSP 244 host processor; e. g. Version 2.01.

9-6

Image 41

Contents DSP For US and Canada only Safety Component has to be Replaced with Original Part onlyContents Unpacking and Warranty DSP 244 FeaturesIntroduction IntroductionFront Panel Controls and ConnectionsControls and Connections 14, Level meter indicators Output 1 13, Channel function indicators SUB, LO, MID, HI15, Compressor indicators Output 1 16, Power ON/OFF-switchRear Panel Installation and Connections Installation and ConnectionsBalanced INPUT/OUTPUT configuration Unbalanced INPUT/OUTPUT configurationLevel Settings Switching the Power onFirst Operation First OperationQuick Start Quick StartLoudspeaker Equalization Over SettingsDelay Alignment Matching the Frequency Response Compressor / Limiter SettingsFull Edit Configurations of the DSPConfigurations of the DSP Stereo 2 Way N Figurations of the DSP3 Way / Mono Sub + Fullrange 3 Way + Fullrange4 Way 3 Way / Independent Sub + Fullrange2-IN-4 Operation E R a T I O NEditing E R a T I O N Store Programs and Program Names Modifying Factory Preset Programs Parameters R a M E T E R SParameter ACCESS-TABLE Parameter AccessParameter LINK-TABLE DefaultDescription of Parameters Master EQ1-5PEQ = 1kHz, Gain = -12dB Routing Master DelayChannel EQ1-4 R a M E T E R S Lopass X-OVER Hipass X-OVERR a M E T E R S Channel Delay Compressor Level LimiterEdit Mode Selection Setting the LCD ContrastT I O N Option FunctionsEdit Protection VU Level Meter Display ModeCompressor and Limiter Threshold Unit Midi RX / TX Channel settings Temperature Unit settingsCelsius FahrenheitTo Midi Send ParametersTo RS232 RS-232 to Midi data transmissionNRS 90246 Contact Closure Interface settings Cntct NRS 90247 RS-485 Interface SettingsPGM U01 PGM MutePeci F I C a T IO N S SpecificationsTechnical Specifications IDI General Midi CommandsMidi Midi System Exclusive ImplementationData Command Parser Code Table Retrofitting Instructions Installation instructions NRSRetrofitting Instructions Installation manuals for interface cards Blockdiagramm / Block Diagram Flussdiagramm / Flow Diagram Abmessungen / Dimensions Garantie Warranty