GTO 10 Control Board Settings, Set Closed Position Limit for Pull-To-Open Applications, To Close

Step 2
IMPORTANT: Connect the BLACK battery wire to the NEGATIVE (–)
battery terminal. Connect the RED battery wire to the POSITIVE (+)
terminal. Reverse connection of battery wires will damage the
control board.
	BLACK
	RED
Step 3	BLACK wire to NEGATIVE (–) terminal
	RED wire to POSITIVE (+) terminal

Plug the transformer

into the electrical outlet. (Use of a surge protector with the transformer is strongly recommended.) IMPORTANT: This is a class II indoor transformer; if using transformer outdoors be sure to enclose it in a weatherproof case.

Control Board Settings

Set Closed Position Limit (for Pull-To-Open Applications)

Step 1		Gate in
Power switch is on, gate		OPEN
is in the OPEN position,	Control	Postion
	Box
operator arm
fully retracted.
	ON/OFF Switch

Step 2

Press the transmitter to activate operator arm. The gate will begin

to CLOSE.

Gate

Closing

Control

Box

Step 3
When the gate reaches
the desired CLOSED	Control	Gate
	Box
position, press
		Closed
the transmitter
to stop the gate.

Step 4
With the gate at the
correct position,	T.
program the closed
limit setting by
pressing and holding
LEARN MAST LIMIT.

S3

LEARN

MAST LIMIT S2

LEARN

2ND LIMIT S4

Learn Master Limit Button

Step 5

Press the transmitter again to allow the gate to return to

the fully OPEN position.

	Gate in
	OPEN
Control	Postion
Box

The gate closed position is now programmed. If you make a mistake and set the limit at the wrong position: press your transmitter to return the gate to the fully opened position, then press and hold the LEARN MAST LIMIT button for 5 seconds. This will clear the memory for the closed limit position. Repeat Steps 1-5.

GTO 4000XLS Instruction Manual © 01.10.12 15