GTO 12, R4854 01, 10 installation manual Adjust the Stall Force Setting, Set Auto Close Time

Adjust the Stall Force Setting

The Stall Force potentiometer on the control board controls the obstruction sensitivity (or the amount of force the operator will apply to an obstruction for two (2) seconds before it automatically stops and reverses direction).

IMPORTANT: For safety reasons the stall force setting will need to be adjusted for your particular application.

The Stall Force potentiometer on the control board operates like a volume control on a radio. Use a small flat blade screwdriver to adjust the potentiometer. Adjust the stall force from the MIN position until the gate operates smoothly without obstructing from its own weight or wind conditions.

NOTE: you may need to increase the stall force in cold temperatures due to increased resistance from gate hinges.

Set Auto Close Time

STALL FORCE

MIN MAX

AUTO CLOSE TIME			STALL FORCE
OFF	120		MIN	MAX
SOFT START OFF		1 2	ON	ON
WARNING	OFF			ON
OPEN	PULL	3 4	DIP	PUS
2ND OPEN DLY.				SIMU
MODE1	OFF			ON
MODE2	OFF			ON

The Auto-Close Time potentiometer controls the Auto-Close feature, and determines how long the gate will remain open (at the fully open position) before it begins to close. The settings for this feature are OFF, or from 3 to 120 seconds.

Adjust the Auto-Close potentiometer by using a small flat blade screwdriver.

	AUTO CLOSE TIME			STALL FORCE
						STATUS
						LEARN RMT
	OFF	120		MIN	MAX	S3
	SOFT START OFF		1 2	ON	ON
	WARNING	OFF			ON	LEARN
	OPEN	PULL	3 4	DIP	PUSH
	2ND OPEN DLY.				SIMULT.	MAST LIMIT
Auto Close Time	MODE1	OFF			ON	S2
	MODE2	OFF			ON
Potentiometer
						LEARN
						2ND LIMIT
						S4

16GTO 4000XLS Instruction Manual © 01.10.12