GTO 12, R4854 01, 10 installation manual Step

Step 1

Close the gate and place your level against the horizontal cross member. Position the level so that the top should be in the center of the cross member and overlaps the post. Scribe a line across the cross member and post.

You will use this line to help determine position of post and gate brackets.

	Step 2
	Position the post bracket on the post with the mounting holes
	centered over the scribe line. The post bracket should be
	flush with the edge of the post closest to the gate. Mark the
	position of post bracket holes on the post.
	Step 3
Carriage Bolts	Drill holes through post as marked using a 1/2” drill bit. Install
	the post bracket using the 1/2” x 10” carriage bolts, 1/2” flat
	washers and lock nuts (provided).­
Metal reinforcement plate
for wood post			3/8" x 3-3/4" Bolt
			3/8" Washer
			Post Bracket
Step 4
Place the end of post pivot bracket with two holes inside the
post bracket. Align the back hole in the post pivot bracket
with back hole in the post bracket.­Insert 3/8” x 3 3/4” hex head		3/8" Washer
bolt and washer through post pivot bracket and post bracket
and secure with 3/8” washer, and lock nut.		3/8" Lock Nut	Post Pivot Bracket

GTO 4000XLS Instruction Manual © 01.10.12 7