GTO 10, R4854 01, 12 installation manual DIP Switch Settings, DIP Switches

DIP Switch Settings

DIP Switches

DIP Switch Settings (MODES)

DIP Switch #1: Soft Start/Stop

ON– Soft start enabled (factory preset).

OFF– Soft start disabled.

The Soft Start/Stop feature slowly starts the gate as it begins to open and slows the gate as it comes

to the closed position. This saves wear and tear on the gate and gate operator system.

DIP Switch #2: Warning Buzzer

ON– Buzzer warning enabled (factory preset).

OFF– Buzzer warning disabled.

The Warning Buzzer alerts you when the gate operator is beginning to either open or close the gate. It sounds for the first 2 seconds in each direction. It also sounds a warning when the gate obstructs two times in one cycle. Switching this to OFF only disables the open and close warning not the obstruction warning.

DIP Switch #3: Push/Pull-To-Open

ON: Push-To-Open.

OFF: Pull-To-Open (factory preset).

If your gate opens into the property the DIP Switch is set to the OFF position (factory setting). If your gate opens out from the property the DIP Switch must be set to the ON position. NOTE: if you have a Push-to-Open gate application you will need a Push- To-Open bracket (see Push-To- Open Instructions on page 21).

DIP Switch #4: Dual Operation

ON– Second opens simultaneously with master.

OFF– Second opens after master (factory preset).

Note: Not applicable for single gate operator.

	1 2	ON
	3 4	DIP
OFF		ON

AUTO CLOSE TIME STALL FORCE

	OFF	120				MIN		MAX
SOFT START OFF					1 2		ON	ON
WARNING			OFF					ON
OPEN			PULL		3 4		DIP	PUSH
2ND OPEN DLY.								SIMULT.
MODE1				OFF				ON
MODE2				OFF				ON

STATUS

LEARN RMT

S3

LEARN

MAST LIMIT S2

LEARN

2ND LIMIT S4

18GTO 4000XLS Instruction Manual © 01.10.12