NAD T975 owner manual Important Information for UK Customers, Blue Neutral Brown Live

Page 3

IMPORTANT SAFETY INSTRUCTIONS

19 Damage Requiring Service - Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a)When the power-supply cord or plug is damaged.

b)If liquid has been spilled, or objects have fallen into the product.

c)If the product has been exposed to rain or water.

d)If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.

e)If the product has been dropped or damaged in any way.

f)when the product exhibits a distinct change in performance-this indicates a need for service.

20 Replacement Parts - When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.

21 Safety Check - Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

22 Wall or Ceiling Mounting - The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

WARNING

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. THE LIGHTNING

FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE

PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHIN THE PRODUCT’S ENCLOSURE THAT MAY BE OF

SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.

THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE OF

IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE

APPLIANCE

CAUTION

Changes or modifications to this equipment not expressly approved by NAD Electronics for compliance could void the user’s authority to operate this equipment.

CAUTION REGARDING PLACEMENT

To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer dimensions including projections) equal to, or greater than, shown below.

Left and Right Panels : 10 cm

Rear Panel : 10 cm

Top Panel : 50 cm

IMPORTANT INFORMATION FOR UK CUSTOMERS

DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. If, nonetheless, the mains plug is cut off, REMOVE THE FUSE and dispose of the PLUG immediately, to avoid possible shock hazard by inadvertent connection to the mains supply. If this product is not provided with a mains plug, or one has to be fitted, then follow the instructions given below:

IMPORTANT

DO NOT make any connection to the larger terminal which is marked with the letter ‘E’ or by the safety earth symbol or coloured GREEN or GREEN AND YELLOW.

The wires in the mains lead on this product are coloured in accordance with the following code:

BLUE - NEUTRAL

BROWN - LIVE

As these colours may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

The BLUE wire must be connected to the terminal marked with the letter ‘N’ or coloured BLACK.

The BROWN wire must be connected to the terminal marked with the letter ‘L’ or coloured RED

When replacing the fuse, only a correctly rated and approved type should be used, and be sure

to re-fit the fuse cover.

IF IN DOUBT CONSULT A COMPETENT ELECTRICIAN

This product is manufactured to comply with the radio interference requirements of EEC DIRECTIVE 89/68/EEC and 73/23/EEC

NOTES ON ENVIRONMENTAL PROTECTION

At the end of its useful life, this product must not be disposed of with regular household waste but must be returned to a collection point for the recycling of electrical and electronic equipment. The symbol on the product, user's manual and packaging, point this out. The materials can be reused in accordance with their markings. Through re-use, recycling of raw materials, or other forms of recycling of old products, you are making an important contribution to the protection of our environment.

Your local administrative office can advise you of the responsible waste disposal point.

Model No. :________________________Serial No. :_________________

3

Image 3
Contents T975 Important Safety Instructions Important Safety InstructionsImportant Information for UK Customers Blue Neutral Brown LiveIf in Doubt Consult a Competent Electrician Panel CONNECTIONS/CONTROLS Front Panel ControlsSpade Wire About the T975 Design PowerdriveSave ALL the Packaging IEC Power SocketInstallation Precautions InputsAuto Trigger ON/OFF Ground ConnectorInput Level Controls Speaker ConnectionsPower SWITCH/STANDBY LED Protection LEDSoft Clipping Light Dimensions and Weights Troubleshooting Problem Cause SolutionSpecifications Amplifier Section IHF Dynamic PowerSvenska Português Italiano Español Deutsch Français English LA Conception Propos DU T975Entrées Précautions Concernant L’INSTALLATIONConnexions / Commandes SUR LA Face Arrière Embase Dalimentation IECConnexions DES HAUT-PARLEURS Commandes DE Niveau D’ENTRÉEMarche / Arrêt DE LA Liaison DE Commande Automatique Entrée DE Commande 12 V TriggerTémoins D’ÉCRÊTAGE Doux Commandes SUR LA Face ParlanteConnecteur DE Mise a Terreground Leds DE ProtectionCaractéristiques Dépannage Problème Cause SolutionSvenska Português Italiano Español Deutsch Français English Über DEN T975 DAS Design PowerdriveEingänge IEC-NETZBUCHSESOFT-CLIPPING EingangspegeleinstellerLautsprecheranschlüsse TRIGGEREINGANG12 V TriggerFrontplattenelemente NETZSCHALTER/STANDBY- LEDBEREITSCHAFTSMODUS-LEDPROTECTION-LEDSCHUTZSCHALTUNG-LED Anzeige VON SOFT-CLIPPINGAbmessungen UND Gewicht Problemlösung Ursache AbhilfeTechnische Daten IHF Dynamische LeistungSvenska Português Italiano Español Deutsch Français English Informatie Omtrent DE T975 HET Ontwerp NAD T975-ZevenkanaalseindversterkerIngangen IEC-AANSLUITINGIngang 12V-TRIGGER Bedieningselementen Voor HET IngangsniveauLuidsprekeraansluitingen Auto Trigger ON/OFF AAN/UITBedieningselementen Frontpaneel Indicatoren ‘SOFT CLIPPING’ Geluidspieken AfkappenAAN/UIT-SCHAKELAAR / STANDBY-LED BEVEILIGINGS-LEDSAfmetingen EN Gewichten Problemen Oplossen Probleem Oorzaak OplossingTechnische Gegevens HF Dynamisch VermogenPage Sobre EL T975 EL Diseño NAD T975 Amplificador De Potencia De Site CanalesEntradas Toma DE Alimentación IECEntrada DEL Disparador DE Controles DE Nivel DE EntradaConexiones DE Altavoz Autodisparador ON/OFFControles DEL Panel Delantero Diodo LED DE Interruptor DE ALIMENTACIÓN/RESERVA StandbyDiodos LED DE Protección Luces DE Soft ClippingPotencia Dinámica IHF Investigación DE Averías Problema Causa SoluciónDimensiones Y Pesos EspecificacionesSvenska Português Italiano Español Deutsch Français English Parliamo DELL’T975 IL Design NAD T975 Amplificatore Di Potenza a Sette CanaliInput Presa DI Alimentazione IECConnettore Massa Comandi Livello DI InputConnessioni Degli Altoparlanti 12V Trigger InputComandi DEL Quadro Anteriore Interruttore DI ALIMENTAZIONE/LED DI StandbyLED DI Protezione Luci Soft ClippingPotenza Dinamica IHF Ricerca Guasti Problema Causa SoluzioneDimensioni E Pesi SpecificheSvenska Português Italiano Español Deutsch Français English Acerca do T975 Design Powerdrivecircuito DE Transmissão DE PotênciaGuarde Todas AS Embalagens Tomada DE Alimentação IECCuidados a TER NA Instalação Notas Sobre O Local DE InstalaçãoEntrada do Disparador DE 12 Comandos do Nível DE EntradaLigações DOS Altifalantes Auto Trigger ON/OFF LIGAR/DESLIGAR Disparador AutomáticoLuzes Indicadoras do Circuito Soft Clipping Ground Connector Terminal DE TerraP1. Interruptor DE Alimentação Power / LED DE Standby Protection Leds Leds DE ProtecçãoDimensões E Pesos Resolução DE Problemas Causa SoluçãoEspecificações Potência Dinâmica IHFSvenska Português Italiano Español Deutsch Français English Konstruktionen NAD T975 Sjukanals EffektförstärkareIngångar IEC NätkontaktIngång FÖR Automatiskt AV OCH Påslag Ingångarnas NivåreglageHögtalarkontakter Omkopplare FÖR Automatiskt AV OCH PåslagKontroller PÅ Apparatens Framsida AV/PÅ Knapp OCH Standby LysdiodKanalindikatorer Soft Clipping IndikatorMått OCH Vikt Felsökning Orsak LösningSpecifikationer IHF Dynamisk EffektSvenska Português Italiano Español Deutsch Français English