Sanyo VCC-WB2000 Alarm Data Recording Capacity, Expansion memory cards, Inserting the memory card

Alarm Setting

5 Check and set the sensitivity.

1Click the [ALARM CHECK] button. The button will appear green for approximately 5 seconds. The movement of objects can only be detected during this time.

2When the sensor detects movement, the ALARM indicator will illuminate red.

This indicator will disappear momentarily when the [ALARM CHECK] button is clicked, and it will illuminate again when further movement is detected.

3To set the sensitivity, select a number (1 to 10) from the MOTION DETECTOR LEVEL drop-down list box.

After selecting a number, repeat steps 1 and 2 to make sure that the sensitivity is set to the optimum level.

6 Set the following alarm recording settings as required.

When an alarm signal is input, the alarm data is stored in the camera’s memory.

•ALARM BUFFERING “ON”

•BUFFERING AREA

•PRIORITY

•ALARM RESOLUTION

•OVERWRITE

7 Once you have finished changing the settings, click the [SET] button.

If an outside intruder comes into the motion sensor detection area, the ALARM indicator will illuminate red on the live image screen.

Alarm Data Recording Capacity

The capacity of the camera’s internal alarm recording area is approximately 16 MB. The alarm recording area is divided into the pre-alarm recording area and the post-alarm recording area. The pre-alarm and post-alarm recording area sizes can be set to one of six settings using the BUFFERING AREA menu command.

In addition, if an expansion memory card has been inserted into the PC card slot at the rear of the camera, alarm data is automatically recorded onto the memory card from the camera’s alarm memory when an alarm is received.

AInserting the memory card

Check that the memory card is facing the correct way, and then insert it and slide the knob to lock it.

BRemoving the memory card

Unlock the card and then press the knob.

A B

Note:

•When inserting and removing the memory card, make sure that ALARM BUFFERING is set to “OFF”, and then turn off the power.

•The PC card slot is for 16-bit 5 V cards only. Do not use 32-bit card bus types of card, as the terminal sections are different.

Expansion memory cards

• The memory cards that can be used are CompactFlash memory cards with a capacity of 16 MB or greater.

• The camera does not have a formatting function. You should format CompactFlash card memory cards using your computer. The only format type that can be used is FAT.

– 38 – English