Transcend Information TS8GCF600, TS16GCF600 dimensions Csel, Gnd

Page 10

TS8G~16GCF600

 

600X CompactFlash Card

 

 

 

 

 

 

 

 

 

 

 

 

Signal Name

Dir.

Pin

Description

-CE1, -CE2

I

7,32

These input signals are used both to select the card and to indicate to the card

whether a byte or a word operation is being performed. -CE2 always accesses

 

 

 

 

(PC Card Memory Mode)

 

 

the odd byte of the word.-CE1 accesses the even byte or the Odd byte of the

Card Enable

 

 

word depending on A0 and -CE2. A multiplexing scheme based on A0,-CE1,

 

 

 

 

-CE2 allows 8 bit hosts to access all data on D0-D7. See Table 27, Table 29,

 

 

 

 

Table 31, Table 35, Table 36 and Table 37.

-CE1, -CE2

 

 

This signal is the same as the PC Card Memory Mode signal.

 

 

 

 

(PC Card I/O Mode)

 

 

 

 

Card Enable

 

 

 

 

-CS0, -CS1

 

 

In the True IDE Mode, -CS0 is the address range select for the task file

 

 

registers while -CS1 is used to select the Alternate Status Register and the

(True IDE Mode)

 

 

 

 

Device Control Register.

 

 

 

 

 

 

 

 

While –DMACK is asserted, -CS0 and –CS1 shall be held negated and the

 

 

 

 

width of the transfers shall be 16 bits.

 

 

 

 

-CSEL

I

39

This signal is not used for this mode, but should be connected by the host to PC

(PC Card Memory Mode)

 

 

Card A25 or grounded by the host.

-CSEL

 

 

This signal is not used for this mode, but should be connected by the host to PC

(PC Card I/O Mode)

 

 

Card A25 or grounded by the host.

-CSEL

 

 

This internally pulled up signal is used to configure this device as a Master or a

(True IDE Mode)

 

 

Slave when configured in the True IDE Mode.

 

 

 

 

When this pin is grounded, this device is configured as a Master.

 

 

 

 

When the pin is open, this device is configured as a Slave.

 

 

 

 

D15 - D00

I/O

31,30,29,28,

These lines carry the Data, Commands and Status information between the host

(PC Card Memory Mode)

 

27,49,48,47,

and the controller. D00 is the LSB of the Even Byte of the Word. D08 is the LSB

 

 

 

 

 

 

6,5,4,3,2,

of the Odd Byte of the Word.

 

 

 

23, 22, 21

 

 

 

 

 

D15 - D00

 

 

This signal is the same as the PC Card Memory Mode signal.

(PC Card I/O Mode)

 

 

 

 

D15 - D00

 

 

In True IDE Mode, all Task File operations occur in byte mode on the low order

(True IDE Mode)

 

 

 

 

bus D[7:0] while all data transfers are 16 bit using D[15:0].

 

 

 

 

 

 

 

 

GND

--

1,50

Ground.

(PC Card Memory Mode)

 

 

 

 

GND

 

 

This signal is the same for all modes.

(PC Card I/O Mode)

 

 

 

 

GND

 

 

This signal is the same for all modes.

(True IDE Mode)

 

 

 

 

 

 

 

 

 

 

Transcend Information Inc.

 

10

 

 

 

 

 

V1.0

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Power Consumption Dimensions Placement FeaturesDescription Transcend Block Diagram TS8G~16GCF600 PC Card Memory Mode PC Card I/O Mode True IDE Mode4 Pin Assignments and Pin TypePC Card Memory Mode PC Card I/O Mode Input Leakage Current Input CharacteristicsOutput Drive Type Output Drive Characteristics Output Drive CharacteristicsSymbol Conditions Signal Name Dir Pin Description Signal Description600X CompactFlash Card Csel GNDHdmardy HstrobeDir Signal NamePin Description REG ResetDmack Ddmardy IordyDstrobe Electrical Specification Output Drive Characteristics for Udma mode Input Power Input Characteristics for Udma modeSymbol Parameter SymbolSignal Interface Signal Card HostPull-up pin 45 BVD2 to avoid sensing their batteries as Low 150 a high state per socketSeries termination required for Ultra DMA operation Ultra DMA Electrical RequirementsTable Typical Series Termination for Ultra DMA Ultra DMA Mode Cabling Requirement Attribute Memory Read Timing Specification Speed Version 300 ns Symbol Ieee Symbol Min ns Max nsTable Configuration Register Attribute Memory Write Timing Speed Version 250 ns Symbol Min ns Max nsMin Max Symbol Common Memory Read Timing SpecificationCycle Time Mode 250 ns 120 ns 100 ns 80 ns Symbol IeeeCommon Memory Write Timing Specification Cycle Time Mode 250 ns 120 ns 100 ns 80 nsData Delay from Wait Rising2 TdIORDY TWTHQV Input Read Timing SpecificationData Delay after Hioe TdHIOE TlGLQV Wait Width Time2 TwIORDY TWTLWTHOutput Write Timing Specification Cycle Time Mode 255 ns 120 ns 100 ns 80 nsMode True IDE PIO Mode Read/Write Timing SpecificationT6Z TS8G~16GCF600 True IDE Multiword DMA Mode Read/Write Timing Specification TS8G~16GCF600 Mode Udma True IDE Ultra DMA Mode Read/Write Timing SpecificationPC Card MEM PC Card IO Mode True IDE Mode UdmaTS8G~16GCF600 Name Name Comment 14.7 Name Mode Mode4Min Max 72.9 50.9Name Min MaxREG Card ConfigurationMultiple Function CompactFlash Storage Cards Selected SpaceDMA Dmardy StrobeDmarq Dmack Stop Hioe Inpack REG Hiow Wait Hioe CMDTable Attribute Memory Function Attribute Memory FunctionDMA CMD REG Configuration Option Register Base + 00h in Attribute Memory TS8G~16GCF600 Pin Replacement Register Base + 04h in Attribute Memory Socket and Copy Register Base + 06h in Attribute Memory DMA CMD Table Pcmcia Mode I/O FunctionTransfer Function REG -CE2Dmarq Dmack Stop Hioe Wait DMA A10 Table PC Card I/O Mode Udma FunctionInpack REG Hiow Wait Hioe CMD A00 DMA REG Common Memory Transfer FunctionTable Common Memory Function CE2 CE1 D15-D8True IDE Mode I/O Transfer Function Metaformat Overview CF-ATA Drive Register Set Definition and Protocol Primary and Secondary Address Configurations Table Primary and Secondary I/O DecodingContiguous I/O Mapped Addressing Table Contiguous I/O DecodingTrue IDE Mode Addressing Memory Mapped AddressingCF-ATA Registers Data Register Address 1F0h170hOffset 0,8,9Sector Number LBA 7-0 Register Address 1F3h173h Offset Feature Register Address 1F1h171h Offset 1, 0Dh Write OnlySector Count Register Address 1F2h172h Offset Cylinder Low LBA 15-8 Register Address 1F4h174h OffsetTS8G~16GCF600 Device Control Register Address 3F6h376h Offset Eh Card Drive Address Register Address 3F7h377h Offset Fh CF-ATA Command Set Command CodeDefinitions Bit Command Check Power Mode 98h or E5hExecute Drive Diagnostic 90h Cyl High Cyl Low Sec Num Sec Cnt FeatureFlush Cache E7h Transcend Information IncErase Sectors C0h Format Track 50hIdentify Device Ech Drive Cyl High Cyl Low Sec Num Sec Cnt FeatureWord Default Total Data Field Type Information BytesXXXXh Command sets enabled PIO data transfer cycle timing modeCommand sets supported Ultra DMA Mode Supported and SelectedCF Advanced PC Card I/O and Memory Timing Mode Capability Word 0 General ConfigurationCF Advanced True IDE Timing Mode Capability and Setting Key management schemes supportedWord 6 Default Number of Sectors per Track Word 1 Default Number of CylindersWord 3 Default Number of Heads Word 49 Capabilities Bit 13 Standby TimerCurrent Number of Cylinders, Heads, Sectors/Track Multiple Sector SettingTotal Sectors Addressable in LBA Mode Current CapacityRecommended Multiword DMA transfer cycle time Words 82-84 Features/command sets supportedWord 68 Minimum PIO transfer cycle time with Iordy Words 85-87 Features/command sets enabled Word 88 Ultra DMA Modes Supported and SelectedWord 89 Time required for Security erase unit completion Word 91 Advanced power management level valueWord 128 Security Status Bit 8 Security Level Value Maximum Multiword DMA timing mode supported Word 160 Power Requirement DescriptionValue Maximum PIO mode timing selected Additional Requirements for CF Advanced Timing ModesValue Maximum Memory timing mode Supported Value Current PIO timing mode selectedValue Maximum Pcmcia IO timing mode Supported Current Multiword DMA timing mode selectedValue Maximum PC Card Memory Udma timing mode Supported Value Maximum PC Card I/O Udma timing mode SupportedValue PC Card Memory or I/O Udma timing mode Selected Initialize Drive Parameters 91h Idle 97h or E3hIdle Immediate 95h or E1h Drive Cyl High Cyl Low Sec Num Sec CntRead Buffer E4h NOP 00hRead DMA C8h Read Long Sector 22h or 23h TS8G~16GCF600 Seek 7Xh Set Features EFh Request Sense 03hFeature Supported TS8G~16GCF600 Standby Immediate 94h or E0h Translate Sector 87h Translate Sector InformationWear Level F5h Write Buffer E8h Write DMA CAh TS8G~16GCF600 TS8G~16GCF600 BBK UNC Idnf Abrt Amnf Drdy DWF DSC Corr ERR Error PostingNOP S. Table Capacity Ordering Information Transcend Product Capacity CompactFlash Card
Top Page Image Contents