Transcend Information TS8GCF600, TS16GCF600 dimensions Metaformat Overview

Page 48

TS8G~16GCF600

600X CompactFlash Card

 

 

 

Host Configuration Requirements for Master/Slave or New Timing Modes

The CF Advanced Timing modes include PCMCIA PC Card style I/O modes that are faster than the original 250 ns cycle time. These modes are not supported by the PCMCIA PC Card specification nor CF by cards based on revisions of the CF specification before Revision 3.0. Hosts shall ensure that all cards accessed through a common electrical interface are capable of operation at the desired, faster than 250 ns, I/O mode before configuring the interface for that I/O mode.

Advanced Timing modes are PCMCIA PC Card style I/O modes that are 100 ns or faster, PC Card Memory modes that are 100ns or faster, True IDE PIO Modes 5,6 and Multiword DMA Modes 3,4. These modes are permitted to be used only when a single card is present and the host and card are connected directly, without a cable exceeding 0.15m in length. Consequently, the host shall not configure a card into an Advanced Timing Mode if two cards are sharing I/O lines, as in Master/Slave operation, nor if it is constructed such that a cable exceeding 0.15 meters is required to connect the host to the card.

The load presented to the Host by cards supporting Ultra DMA is more controlled than that presented by other CompactFlash cards. Therefore, the use of a card that does not support Ultra DMA in a Master/Slave arrangement with a Ultra DMA card can affect the critical timing of the Ultra DMA transfers. The host shall not configure a card into Ultra DMA mode when a card not supporting Ultra DMA is also present on the same interface

When the use of two cards on an interface is otherwise permitted, the host may use any mode that is supported by both cards, but to achieve maximum performance it should use its highest performance mode that is also supported by both cards.

Metaformat Overview

The goal of the Metaformat is to describe the requirements and capabilities of the CompactFlash Storage Card as thoroughly as possible. This includes describing the power requirements, IO requirements, memory requirements, manufacturer information and details about the services provided.

Table: Sample Device Info Tuple Information for Extended Speeds

Note: The value “1” defined for D3 of the N+0 words indicates that no write-protect switch controls writing the ATA registers. The value “0” defined for D7 in the N+2 words indicates that there is not more than a single speed extension byte.

Transcend Information Inc.

48

V1.0

Page 47 Page 49
Image 48
Page 47 Page 49
Contents Placement Features Power Consumption DimensionsDescription Transcend Block Diagram TS8G~16GCF600 PC Card Memory Mode PC Card I/O Mode True IDE Mode4 Pin Assignments and Pin TypePC Card Memory Mode PC Card I/O Mode Input Characteristics Input Leakage CurrentOutput Drive Type Output Drive Characteristics Output Drive CharacteristicsSymbol Conditions Signal Description Signal Name Dir Pin Description600X CompactFlash Card Csel GNDHdmardy HstrobeSignal Name DirPin Description Reset REGDmack Iordy DdmardyDstrobe Electrical Specification Input Power Input Characteristics for Udma mode SymbolOutput Drive Characteristics for Udma mode Parameter SymbolSignal Interface Signal Card HostPull-up pin 45 BVD2 to avoid sensing their batteries as Low 150 a high state per socketUltra DMA Electrical Requirements Series termination required for Ultra DMA operationTable Typical Series Termination for Ultra DMA Ultra DMA Mode Cabling Requirement Attribute Memory Read Timing Specification Speed Version 300 ns Symbol Ieee Symbol Min ns Max nsTable Configuration Register Attribute Memory Write Timing Speed Version 250 ns Symbol Min ns Max nsCommon Memory Read Timing Specification Cycle Time Mode 250 ns 120 ns 100 ns 80 ns SymbolMin Max Symbol IeeeCommon Memory Write Timing Specification Cycle Time Mode 250 ns 120 ns 100 ns 80 nsInput Read Timing Specification Data Delay after Hioe TdHIOE TlGLQVData Delay from Wait Rising2 TdIORDY TWTHQV Wait Width Time2 TwIORDY TWTLWTHOutput Write Timing Specification Cycle Time Mode 255 ns 120 ns 100 ns 80 nsTrue IDE PIO Mode Read/Write Timing Specification ModeT6Z TS8G~16GCF600 True IDE Multiword DMA Mode Read/Write Timing Specification TS8G~16GCF600 True IDE Ultra DMA Mode Read/Write Timing Specification PC Card MEM PC Card IO ModeMode Udma True IDE Mode UdmaTS8G~16GCF600 Name Name Comment Name Mode Mode4 Min Max14.7 72.9 50.9Name Min MaxCard Configuration Multiple Function CompactFlash Storage CardsREG Selected SpaceDmardy Strobe Dmarq Dmack Stop HioeDMA Inpack REG Hiow Wait Hioe CMDAttribute Memory Function Table Attribute Memory FunctionDMA CMD REG Configuration Option Register Base + 00h in Attribute Memory TS8G~16GCF600 Pin Replacement Register Base + 04h in Attribute Memory Socket and Copy Register Base + 06h in Attribute Memory Table Pcmcia Mode I/O Function Transfer FunctionDMA CMD REG -CE2Table PC Card I/O Mode Udma Function Dmarq Dmack Stop Hioe Wait DMA A10Inpack REG Hiow Wait Hioe CMD A00 Common Memory Transfer Function Table Common Memory FunctionDMA REG CE2 CE1 D15-D8True IDE Mode I/O Transfer Function Metaformat Overview CF-ATA Drive Register Set Definition and Protocol Primary and Secondary Address Configurations Table Primary and Secondary I/O DecodingContiguous I/O Mapped Addressing Table Contiguous I/O DecodingTrue IDE Mode Addressing Memory Mapped AddressingCF-ATA Registers Data Register Address 1F0h170hOffset 0,8,9Feature Register Address 1F1h171h Offset 1, 0Dh Write Only Sector Count Register Address 1F2h172h OffsetSector Number LBA 7-0 Register Address 1F3h173h Offset Cylinder Low LBA 15-8 Register Address 1F4h174h OffsetTS8G~16GCF600 Device Control Register Address 3F6h376h Offset Eh Card Drive Address Register Address 3F7h377h Offset Fh CF-ATA Command Set Command CodeDefinitions Check Power Mode 98h or E5h Execute Drive Diagnostic 90hBit Command Cyl High Cyl Low Sec Num Sec Cnt FeatureTranscend Information Inc Erase Sectors C0hFlush Cache E7h Format Track 50hDrive Cyl High Cyl Low Sec Num Sec Cnt Feature Word Default Total Data Field Type InformationIdentify Device Ech BytesPIO data transfer cycle timing mode Command sets supportedXXXXh Command sets enabled Ultra DMA Mode Supported and SelectedWord 0 General Configuration CF Advanced True IDE Timing Mode Capability and SettingCF Advanced PC Card I/O and Memory Timing Mode Capability Key management schemes supportedWord 1 Default Number of Cylinders Word 3 Default Number of HeadsWord 6 Default Number of Sectors per Track Word 49 Capabilities Bit 13 Standby TimerMultiple Sector Setting Total Sectors Addressable in LBA ModeCurrent Number of Cylinders, Heads, Sectors/Track Current CapacityWords 82-84 Features/command sets supported Recommended Multiword DMA transfer cycle timeWord 68 Minimum PIO transfer cycle time with Iordy Words 85-87 Features/command sets enabled Word 88 Ultra DMA Modes Supported and SelectedWord 91 Advanced power management level value Word 89 Time required for Security erase unit completionWord 128 Security Status Bit 8 Security Level Word 160 Power Requirement Description Value Maximum PIO mode timing selectedValue Maximum Multiword DMA timing mode supported Additional Requirements for CF Advanced Timing ModesValue Current PIO timing mode selected Value Maximum Pcmcia IO timing mode SupportedValue Maximum Memory timing mode Supported Current Multiword DMA timing mode selectedValue Maximum PC Card I/O Udma timing mode Supported Value Maximum PC Card Memory Udma timing mode SupportedValue PC Card Memory or I/O Udma timing mode Selected Idle 97h or E3h Idle Immediate 95h or E1hInitialize Drive Parameters 91h Drive Cyl High Cyl Low Sec Num Sec CntNOP 00h Read Buffer E4hRead DMA C8h Read Long Sector 22h or 23h TS8G~16GCF600 Seek 7Xh Set Features EFh Request Sense 03hFeature Supported TS8G~16GCF600 Standby Immediate 94h or E0h Translate Sector 87h Translate Sector InformationWear Level F5h Write Buffer E8h Write DMA CAh TS8G~16GCF600 TS8G~16GCF600 Error Posting BBK UNC Idnf Abrt Amnf Drdy DWF DSC Corr ERRNOP S. Table Capacity Ordering Information Transcend Product Capacity CompactFlash Card
Top Page Image Contents