Cleaning the feed module tires and separation roller tires
Replacing lamps
The cleaning procedures below should be performed daily. More frequent cleaning may be necessary depending on throughput and document type. Daily cleaning of the feed module tires and separation roller tires prevent ink, toner, dust and paper contaminates from collecting on the rollers, which help documents to separate properly when feeding.
1.Open the swing out door.
2.Remove the feed module.
3.Lift the roller cover.
4.Remove the feed module and separation roller.
5.Rotate the feed module tires and separation roller tires and scrub with an Emulsiclean wipe. Continue cleaning until all residue is removed from the tires.
6.Dry the tires with a dry,
7.Reinstall the separation roller.
8.Lower the roller cover.
9.Reinstall the feed module.
10.Close the swing out door.
There are four identical lamps in the scanner. Replace all lamps using the same procedure.
CAUTION: Lamps that have been operating are HOT. Before attempting to replace the lamps, make sure the scanner is turned off and you have allowed the lamps to cool for at least 10 minutes.
1. Open the
|