Kodak i800 Series manual Message Description Print head not present Action

Message	Description
Message	Print head not present
Action	An attempt was made to use the Document Printer and no print head is installed.
	Be sure the cables are properly connected to the print head and printer board. Be
	sure the print cartridge is installed in the print head assembly. See Chapter 4,
	Document Printer and Patch Reader for procedures.
Message	Rear image cal unsuccessful
Action	The imaging calibration for the rear camera was unsuccessful. Clean the imaging
	guides and retry calibration. See Chapter 5, Maintenance, “Cleaning the imaging
	guides” for cleaning procedures.
Message	Refeed document set
Action	The documents are too close together as they enter the scanner. Replace the
	separation roller tires and pre-separation pad. See Chapter 5, Maintenance for
	instructions.
	One or more documents that passed through the transport were not scanned.
	Refeed all documents for which images were not obtained.
	A hole or tear in the document triggered a false count on the exit sensor. Align
	documents so that holes and tears do not pass beneath the left feed tire.
Message	Replace lamps soon
Action	You will need to replace all four lamps soon. See Chapter 5, Maintenance
	regarding lamp replacement procedures.
Message	S1 sensor is blocked
Action	A document may be blocking the S1 sensor. Clear the paper path by following the
	procedures outlined earlier in this chapter. See the diagram at the end of this
	document for the approximate location of this sensor.
Message	S2 sensor is blocked
Action	A document may be blocking the S2 sensor. Clear the paper path by following the
	procedures outlined earlier in this chapter. See the diagram at the end of this
	document for the approximate location of this sensor.
Message	Self-test failed
Action	One of the scanner subsystems failed self-test. The subsystem’s functionality will
	not be available. Turn the power off and on again and perform another self-test. If
	the problem persists, call Service.
Message	Self-test passed
Action	Informational message. The self-test performed was successful.
Message	Sequential count overflow
Action	The sequential count overflowed. Reconfigure the scanner to allow a larger value
	for sequential count.
Message	Settings conflict
Action	Conflicting or unacceptable settings have been downloaded to the scanner. For
	example, if you attempt to set a 200 dpi bi-tonal front with a 300 dpi bi-tonal rear or
	if you try to enable color scanning on a Kodak i810 or i830 Scanner.

A-61169 July 2003 6-9