Kodak i800 Series manual Enabling and disabling, Scanner

Enabling and disabling	The five buttons at the bottom of the Control Panel correspond to the
the scanner	icons above the buttons To activate the icons, press the corresponding
	button.

Icons

Control panel buttons

Enabling the scanner The scanner can only be enabled from the host computer. When the scanner is enabled, you can change the image address level, override the elevator setting and use the programmable keys. When enabled, the icons on the Operator Control Panel will look like this:

These functions can be performed when the scanner is enabled:

Increments the image address level. Depending on the image address level the icon may appear as follows:

indicating the next image address is level 3

indicating the next image address is level 2

indicating the next image address is level 1

Lowers the elevator tray if it is not already in the lowest position.

Performs the first programmable function.

Performs the second programmable function.

Performs the third programmable function.

NOTE: Programmable keys are set-up during application setup. Check with your system administrator for the function of each programmable key. Possible programmable key assignments are as follows:

∙No scanner functionality (default)

∙Scanner End-of-Job

∙Terminate Batch

∙Omit Multi-feed Detection on Next Document

∙Omit Printing on Next Document

∙Omit Patch Reading on Next Document

3-2 A-61169 July 2003