Kodak i800 Series manual Message Listing

Message Listing	Following is a list of messages and corrective actions you can take if one
	of the following messages appears on the Operator Control Panel. Most
	corrective actions can be found in this User’s Guide; appropriate chapters
	are referenced.
	If one of the following messages appears, take the following action:
	∙ Determine whether or not the error can be addressed from the host
	system.
	∙ If the error cannot be addressed by the host system, attempt to clear
	the error by taking the action listed below.
	∙ If the prescribed action(s) does not clear the error, initiate a controlled
	power-down sequence:
	Controlled Power-down Sequence
	1. Wait for all information currently held in the buffer to be transferred to
	the host system.
	2. Turn off the scanner.
	3. Wait 30 seconds.
	4. Turn the scanner back on.
	If the error condition is not cleared after using the controlled power-down
	sequence, call Service.
Message	Description
Message	Calibrate scanner now
Action	You must calibrate the scanner now. See Chapter 3, Operator Control Panel
	Functions for calibration procedures.
Message	Calibrate scanner soon
Action	Calibrate the scanner when the current batch has completed. See Chapter 3,
	Operator Control Panel Functions for calibration procedures.
Message	Calibration failed
Action	Perform a controlled power-down sequence and recalibrate the scanner. Be sure
	you are using the correct calibration target. Clean the imaging guides. See
	Chapter 3, Operator Control Panel Functions for the correct calibration target. If
	the message persists, call Service.
Message	Calibration succeeded
Action	Informational message. The scanner has been successfully calibrated.

A-61169 July 2003 6-5