Kodak i800 Series manual Message Description Feeder self test failed Action

Message	Description
Message	Feeder self test failed
Action	The self-test of the paper feeder failed. Perform a controlled power-down
	sequence on the scanner. If the problem persists, call Service.
Message	Front image cal unsuccessful
Action	The imaging calibration for the front camera was unsuccessful. Clean the
	imaging guides and retry calibration. See Chapter 5, Maintenance, “Cleaning the
	imaging guides” for cleaning procedures.
Message	Image address field overflow
Action	One of the image address fields has exceeded its maximum configured count.
	Check to make sure that a level change was not missed or reconfigure the
	scanner to allow a larger value for the overflowed field.
Message	Image buffer almost full
Action	The feeder has stopped and the transport is still running because the image buffer
	is almost full. Processing will resume when the buffer is less full.
Message	Image buffer full
Action	The image buffer overflowed.
	One or more documents that passed through the transport were not scanned.
	Refeed all documents for which images were not obtained.
Message	Images in buffer
Action	You tried to enable the scanner when images were still in the buffer. Not all
	images were retrieved. Retrieve the remaining images or clear the buffer. When
	the buffer is cleared, you may enable the scanner.
Message	Interlocks are closed
Action	Informational message. All doors are closed.
Message	Interlocks are open
Action	One of the doors is not closed or an error has not been cleared since the door(s)
	was last opened. Check to see that all doors are closed and clear the error by
	pressing the Return arrow (left button) on the Control Panel.
Message	Invalid IA level
Action	The image address level you tried to enter is not valid. Re-enter a correct image
	address level. For more information about image addressing, see Kodak
	publication, Kodak i800 Series Scanners, Image Processing Guide, A-61510.
Message	IPB needs firmware
Action	There is no firmware in an image processing board. Firmware needs to be
	installed in all image processing boards before scanning is possible. Call Service.
Message	Lamps not ready
Action	Calibration and/or scanning was attempted before the lamps were warmed up.
	See Chapter 3, Operator Control Panel Function’s for calibration guidelines and
	procedures.
Message	Lamps ready for scanning
Action	Although lamps have warmed up sufficiently to allow scanning, image quality will
	be best after the lamps have stabilized after approximately 10 minutes.

A-61169 July 2003 6-7