Edimax Technology IC-7000 user manual Renew List

`

IP CAM List

Renew List

MAC address

IP CAM Name

IP address

Subnet Mask

Default Gateway

Communication Port

Audio Port number (UDP)

IC-7000 CAM User’s Guide

Pan/Tilt IP Surveillance Camera

		Version of
		CAM_EZ
		Search
		Display the way
		to get IP
		Version of IP CAM
		Choose the
		way to get IP
		Key in PPPoE
	PPPoE Account
		Submit
		settings
		Renew
figure 1		executed to
		obtain an IP

圖(一)

2.2USE IP-CAMAND TEST THE FUNCTIONALITY FOR THE FIRST TIME

※The following network architecture is suitable for IP-CAM test/ IP address change (static IP address) /firmware update (strongly recommended).

Please refer to the following instructions:

A.Installing the camera for the first time:

zYou computer must be equipped with network card and RJ-45 network connector.

zConnect the RJ-45 jack which is located at the rear of IP-CAM with the red test network cable. One end is connected to the network jack of computer; the other end is connected to the network jack located at the rear side of the IP-CAM.

zConnect the power adaptor to the power port (on the rear) of IP-CAM. Now, the status LED on the top of IP-CAM will be illuminated.

IC-7000 USER’S GUIDE PAGE 10/62 Rev. PV1.0