Edimax Technology IC-7000 user manual 11/62

`

IC-7000 CAM User’s Guide

Pan/Tilt IP Surveillance Camera

B. Make sure the IP addresses of PC and IP CAM are on the same network section:

zUsually, static IP address will be used to access Internet, so the IP address will vary. When you want to change IP address, please write down the original IP address on your computer first. Then you have to modify the IP address of your computer for testing if the IP-CAM can be operated normally or not. After finishing the test, IP address for your computer should be recovered to original settings.

zIn general, the IP address for your computer in LAN will be set with “Obtain an IP address automatically”. To test the IP-CAM is working properly or not, the IP address of your computer must be changed temporarily. After the test is finished, it can be changed back to original setting.

C.Next, choose Control Panel->Network Connections->choose the activated area

Network Connections---> right click your mouse --->select Properties(P)---> Select Internet Protocol (TCP/IP)---> Select Properties(R) , then you can check the current IP address status for the computer. The way to modify IP address is:

IP Address(I):192.168.9.5

Subnet Mask (U):255.255.255.0

Default Gateway(D):192.168.9.254

D.Open and execute CAM_EZ Search (as shown in Figure 2). The system will scan the IP-CAM that you just installed automatically. Then, you will find 255IC-7000 in the column of Camera Lists. Click 255IC-7000 with left mouse button. You can see the default settings of IP-CAM.

IC-7000 USER’S GUIDE PAGE 11/62 Rev. PV1.0