`
IC-7000 CAM User’s Guide
Pan/Tilt IP Surveillance Camera
5.3.1Event
Event settings, including:
-Motion Detection (set 1)
-Motion Detection (set 2)
Individual or both set signal input triggers can be selected.
How to Use Event Settings:
Step 1. Activate Event for either set (Trigger sensitivity will be displayed automatically for MD)
Step 2. After you finished, click Submit; otherwise;
Step 3. Click Default to use factory default settings (sets all to off).
Note: After engaging either type of event, “Save in PC” will be switched on automatically.
5.3.2Trigger
Event trigger image transfer settings, including:
-Save in PC:The image file is saved in your computer.
-Save in Flash Card:The image file is saved in the SD card.
-Mail Image:Send captured event trigger image file by
-FTP Image: Send captured event trigger image file by FTP.
-Shutter Timer:Change shutter time for event trigger image capture; Default setting is 2 seconds.
5.4NETWORK SETUP
Network Setup can be used to change the network settings of the IP CAM. The default setting for IP assignment is “static”. Available settings are:
-IP Assignment:Static, DHCP, or PPPoE
-PPPoE settings (PPPoE is the most common type of Broadband Internet connection, where your ISP assigns a different IP address to your connection each time you log on)
-Http Server port settings
-Audio Port Settings
-DNS settings
MAC Address:Displays the Mac address of the IP CAM
PAGE 40/62 | Rev. PV1.0 |