Edimax Technology IC-7000 user manual 23/62

`

		IC-7000 CAM User’s Guide
		Pan/Tilt IP Surveillance Camera
Scenario 6
	The way to access Internet	ADSL or Cable Modem
	Public IP address required?	Yes, one dynamically-allocated public IP
		address is required
	DHCP server required?	Must be equipped with DHCP and NAT
		function
	Network Setup for IP -CAM	LAN Enable / Manually
	This scenario is best for:	Users with several dynamic IP addresses and
		several IP-CAMs installed

1.Please obtain the PPPoE username and password from your ISP.

2.Connect the red test network cable to the RJ-45 Ethernet jack located on the rear of IP-CAM. The other end is connected to the network card of computer

3.Refer to 2.4-3 PPPoE - IP Address Settings to input PPPoE account and password.

4.Please type the Mail server setup information in IP-CAM setup utility.

5.Connect IP-CAM to LAN Hub.

6.Use CAM_EZ Search utility to find out the dynamic IP address assigned by ISP for each IP-CAM.

7.Open IP browser and type in the physical IP address (such float IP is dispatched by ISP) of the IP-CAM, e.g., http://211.78.174.94.

8.Follow the steps above to configure for each IP-CAM.

二. IP-CAM Network Framework Installation 7

The way to access Internet	ADSL or Cable Modem
Public IP address required?	One static public IP address required
DHCP server required?	Must be equipped with DHCP and NAT

IC-7000 USER’S GUIDE PAGE 23/62 Rev. PV1.0