Edimax Technology IC-7000 user manual Refer to 2.4-1 Static IP Address Settings to get instructed

`

IC-7000 CAM User’s Guide

Pan/Tilt IP Surveillance Camera

refer to 2.4-1 STATIC - IP Address Settings to get instructed.)

3.For the instruction of port mapping function of residential router, please refer to IP and port settings of camera to make proper configuration.

4.To view the image of IP-CAM from remote computer: Launch IP browser and type the public IP address of the residential router and the port number of IP-CAM, e.g.,

http:// 211.78.174.01:1025.

Scenario 3

The way to access Internet	ADSL or Cable Modem
Public IP address required?	Yes, a dynamically-located IP address is
	required
DHCP server required?	Must be equipped with DHCP and NAT
	function
Network Setup for IP -CAM	LAN Enable / Manually
	Every IP-CAM need an unique port number
This scenario is best for:	Users with dial-up ADSL, one dynamic IP
	address and several IP-CAMs installed

1.Activate PPPoE function of residential router. Then, set private IP address and activate the DHCP server function of residential router. When the dial-up procedure of ADSL is completed, you will get a dynamically-allocated IP address from your ISP.

2.In the IP configuration for each IP-CAM, please assign an unique private IP address for every IP CAM. For Http Port setting, please specify an unique port number for each IP CAM also. (Please refer to 2.4-1 STATIC - IP Address Settings to get instructed)

3.For the instruction of port mapping function of residential router, please refer to IP

IC-7000 USER’S GUIDE PAGE 20/62 Rev. PV1.0