JVC VN-C215V4U manual Camera unit/Inside the camera, Power supply/Alarm signal cable a Pg, Strap

Camera unit/Inside the camera

TThis is when the dome cover, inner cover and outer case is removed. How to remove ( A Pg. 17 eMounting on a ceilingf Steps 3. to 5.)

W

Lens section (A Pg. 13)

J

K

L

M

N

H Power supply/Alarm signal cable (A Pg. 24, 26)

Signal name	Cable color
Alarm input 1	Pink
Alarm input 2	Blue
Alarm output 1	Orange
Alarm output 2	Yellow
GND	Brown
DC 12 V power supply+	Red
DC 12 V power supply-	Black

Note：

●Do not use PoE together with DC 12 V power supply. Simultaneous connection will cause failure or malfunction.

I[10BASE-T/100BASE-TX(PoE)] Connector for LAN cable connection (RJ-45)

(A Pg. 26)

JStrap

This sheet connects the camera unit to the dome cover.

Behind the camera unit

V

UP

T Y

MAC address

S

R X

Q

P

O

K Fastening screw (x3)

This is the screw head of the ceiling mounting bracket Q, which is used to embed the camera in the ceiling.

L [RESET] Reset button

This is a button for rebooting the camera. Press this button and release within 5 seconds to reboot the camera. It takes about 1 minute for the camera to reboot. During startup, [RESET] button is disabled.

Note：

●Pressing the [RESET] button for 5 seconds or longer switches the camera to the service verification mode. Do not press the button for 5 seconds or longer.

M [MONITOR] Monitor terminal (RCA pin) (A Pg. 27)

N Camera unit

OFall-prevention wire fastening hook

PFall-prevention wire (supplied) and wire

mounting screw

Connect the camera unit N and the outer case C with the fall-prevention wire fastening screw O.

11