Introduction
Name and Function of Parts
Camera unit
A
B
C
I
H
B
A
G 
D | F |
| |
| Status |
E | Link |
Act |
A Mounting hole (elliptical) 4
Use these when mounting the camera to the electrical box.
(A Pg. 22)
B Mounting hole (round) 4
Use these when mounting the camera to the ceiling or wall. (A Pg. 20)(A Pg. 22)
C Outer case
Use this in the following cases:
●When mounting the camera directly to the ceiling or on the wall.(A Pg. 20)
●When mounting the camera to the electrical box. (A Pg. 22)
D Dome cover
The dome cover is fragile. Take care when handling it.
E Inner dome
Before mounting the camera, remove it and perform image angle setting.
(A Pg. 18)(A Pg. 20)
F Operation check indicator [Status] Status indicator
This indicator appears blinking when the power is turned on and turns off when the camera startup is completed. Check the camera or the connected device if the indicator remains blinking when the camera is in use.
[Link] Link indicator
This indicator lights up when the camera is linked or connected to the network.
[Act] Activity indicator
This indicator lights up during an activity such as data transmission or reception.
G Cable ejector hole
This is used for pulling cables from the side of the camera unit without drilling a hole in the ceiling.
(A Pg. 22)
10