JVC VN-C215V4U Open a hole in the ceiling R35 mm,1-3/8 inches, Configure image settings. a Pg

Setup

Mounting the Camera (continued)

Mounting the camera directly on a ceiling or alongside a wall

To mount on a wall, use the same procedures below but replace the word “ceiling” with “wall”.

Setup

1. Open a hole in the ceiling (R35 mm,1-3/8 inches)

Use the attached template to drill a hole in the ceiling.

2. Draw the fall-prevention wire, LAN cable, power cable and alarm cable from the ceiling. These are mounted beforehand on the ceiling slab. (The fall-prevention wire is not supplied)

Note：

●Also pay careful attention to the length, strength, wiring and material (insulation quality) of the fall-prevention wire to be used.

●For the fall-prevention wire, the inside diameter of the ring section to be mounted on the camera unit should be between R3.1 mm and R5.5 mm, and the outside diameter should be below R9 mm.

5. Remove the outer case.

A Loosen the camera fastening screws with a screwdriver.

BTurn the camera in the anti-clockwise direction and remove the outer case.

CRemove the fall-prevention wire from the fastening hook

6. Loosen the pan fastening screw.

Note：

●The lens section may be damaged if you operate it without loosening the pan fastening screw.

7. Configure image settings. (A Pg. 13)

Inner dome

5 A

74 6 Pan fastening screw

	Camera Fastening
	Screw
5B	5 C

R35 mm

1 (1-3/8 inches)

Fall-prevention wire (not supplied)

Power cable, alarm cable

LAN cable

3. Remove the dome cover.

2

Approx. 100 mm (3-7/8 inches)

Connection

1. Face the imaging direction mark (j) in the shooting direction and mount the outer case on the ceiling.

About the outer case mounting screws (not supplied):

● Use a screw head of less than 3 mm.

● The mounting hole of the outer case is R

4.5 mm.

● Do not use a flat countersunk head screw.

● When using an impact driver, do not

As shown in the picture, hold the dome ring such that the position alignment mark is between your thumb and index finger. Turn the dome ring in the anti-clockwise direction and remove.

Dome ring	Position
	alignment mark

4. Remove the inner dome.

The inner dome is secured by 3 clips. Remove the inner dome from the clips.

tighten right to the end. Tighten with your

hand. The outer case may be damaged.

2. Hitch the fall-prevention wire that was

removed in Setup step 4 on the fastening

hook.

3. Mount the fall-prevention wire on the

camera. This wire connects the camera to the

ceiling.

(The fall-prevention wire is not supplied.)

Note：

● Tighten all screws securely. Otherwise the

camera may come loose and fall.

20